Malibu landscape lights do not work!?

Question

I hooked the transformer up, hooked the first wires in to a and b and spliced the lights in and nothing. They are the ones from home depot, it comes with 4 little spotlights. Any ideas?

Answer 1

I have used a bunch of those and never had any problem-----suggest that you put the transformer (tsf.) on a work table and plug-in to 110v outlet and take one fixture and use it to test the tsf. to see that it is functioning properly____ if not--- return it to the H.D. store and start over with same test----- those wires are hard to seat into the black cable and sometimes you have to ice-pick a hole into the cable to make a good connection to the 12volt tsf and the lamp fixture____ check the connectors ,,,one at a time .........there are different lamp to cable connections .....some of them are better than others______ they will do a nice job of lighting your front steps or the driveway edge don't get discouraged -- end result is worth the labor........

Answer 2

It is probably where you connect the wire to the fixture. Those damn little clamping connections rarely work the first time, sometimes you have to reposition and even skin the wire a bit for them to connect.

Answer 3

specific, yet be careful approximately doing it. The fee present day shouldn't in any respect be better than 10% of the cellular's mAh score. maximum image voltaic lights furniture use rather low-means cells (generally six hundred mA), making 60 mA the optimal stated fee present day. maximum chargers are designed for a lot greater currents than this. you could might desire to locate a D-I-Y charging circuit which you will alter. I made one that is limited to 50mA by technique of technique of a small incandescent lamp of that score in series with the cellular holder.

Answer 4

Use a meter and see if it putting out voltage on the a and b terminals, if not take it back, also if it is putting out voltage check the bulbs, you can also check that the wire is good.