i need help with my screen resolution?

Question

im trying to get my movie maker to work but after i click on the program a screen comes up and says

you system is currently set to a screen resolution of 800x600 or less.
better display results can be achieved if you set your screen resolution to 1024x768 or highter

how can i get it to 1024x768

Answer 1

right click on desktop >go to setting tab > u will see a slider below where u can move the to the right to achive 1024x768
note : u can run movie maker in 800x600

Answer 2

To change your screen resolution (assuming you're using Windows):

1.) Open Display in Control Panel.

2.) On the Settings tab, under Screen resolution, drag the slider, (to 1024x768 or higher) and then click Apply.

3.) When prompted to apply the settings, click OK. Your screen will turn black for a moment or two (don't worry - this is "normal")

4.) Once your screen resolution changes, you have 15 seconds to confirm the change. Click Yes to confirm the change; click No or do nothing to revert to your previous setting.

Note: You should be all set after that - If you want to change it back again; or to try some other setting - just repeat steps 1-4 again (and pick a different resolution).

Also, you might want to copy these instructions to either a Notepad or Word document for future reference :)

Good Luck!

Answer 3

I think this will help you...
Right click on the desktop>Settings>on the bottom you will see a Slider Bar under the Screen resolution Section there drag the slider to the right hand side by one point> click Ok.

All done...

Hope this helps you...

Be carefull while doing this if you are using an old computer or a monitor Higher Resolutions( Higher that 1024 X 768) Might not be support. the Screen might Go blank for a while and then it might come back.

Answer 4

ok what you do i on your desktop click the right mouse button and the click properties. then go to settings and it says the screen resolution. pull the slider so it says the desired screen resolution you want and then press ok and then try windows movie maker after that.

Answer 5

ّFirst, your monitor and graphic card must support it
If you think they do, then in windows XP, right click on an empty part of your desktop screen and choose "Properties" then in the window that appears click on "Settings" tab then in the lower part choose the resolution that you want
other windows versions are similar to this

Answer 6

You need to close or minimize any opened folders so you see just screen as it would apper after start-up 'right click' with mouse then sellect properties,-after properties screen is displayed sellect settimgs(top right) you'll then see options to better the screen resulution here!remember to sellect ''apply''
& then O.K. ! You have successfully changed your resulution.

Answer 7

right hit on da .desktop >properties >settings tab
reset ur screen resolution to what you need hit on >>Apply & ok