Best method for weaving in ends on a crochet project?

Question

marilyn -- So I am discovering!

Answer 1

Since there may be multiple strings depending on if there is more than one color or more than one skein I use two different methods. The end from the begining chain or any ends contained within the work I bring this end back on top of the chain stitch as I am getting ready to go over it with the second row. I usually start this about ten stitches from the end and just work the stitch as normal but the tension from the stitch holds the end in place better than weaving.

For the last row where you fasten off:

There are two loops on the top of each stitch, with a tapestry needle whipstitch around one loop then whipstitch around the opposite loop one stitch further back from the last. This way again like the weaving in the earlier stitches the ends "give" with stretching but do not come undone.

Hope this helps!!

Answer 2

Whenever possible, crochet over the ends as you go. make sure to do that for at least two inches. If you can't do that, use a tapestry needle. ( it is large and has a big eye-some are plastic.) Weave in one direction for an inch or two and then go in a different direction for another inch or two.

Don't wait until you are all done to do it ---- it is much easier to do them as they come up. If you wait, it will take FOREVER!

Answer 3

I have two ways I do this depending on the project.

One is to use a hook about 2 sizes smaller than the one I used for the project and pull the thread or yarn through several stiches.

Another way to do it is to use a tapestry or other blunt needle and do something similar weaving in and out.

best,

cez

Answer 4

I use my hook and take the tail (end of yarn/thread) back through the stitches I have made at the end. under left, under right, and so on. need to leave two inches, if you have tucked it under 3 or 4 stitches, you can cut the excess if there is any.