I want to install a tub surround over the three tile walls of my shower. Do I need to do anyhting to the tile first like treat it with an antifugal paint of something? (I don't want to do the tub itself, just the walls)
2006-12-29 06:29:38 · 7 answers · asked by Anonymous in Home & Garden ➔ Do It Yourself (DIY)
Yep, Twice, and that was at least one too many times.
To do the job properly, though I always advise against the (surround) choice, you need to remove the tile.
Steven Wolf
(The Rev.)
2006-12-29 09:59:58 · answer #1 · answered by DIY Doc 7 · 1⤊ 0⤋
Professional install for showers: remove drywall stopping 1 inch below edge of tile, install 5mil poly liner to studs, cover with 1/2 duroc or concrete backer board. Fill gap at bottom with silicone sealant. Then install tile.
Quick cheap way for tub BACKSPLASH ONLY: Use Mapei type 1 or other suitable mastic, skim walls with flat side of trowel, allow it to skin over. then install tile. Theoretically that prevents steam and moisture vapor from intruding into the drywall. BUT experience has shown this is not the case, but since this method is not for a shower unit it will suffice. But never use that method on an area that will see direct contact with water. Grout is not waterproof, water will soak through and get into the drywall, static pressure will help push it through and it will force you to tear out the ceramic and drywall starting over from scratch. It also allows for a potential mold problem from condensation which can only be prvented by the poly vapor barrier.
2006-12-29 06:39:27 · answer #2 · answered by Anonymous · 0⤊ 0⤋
25 years ago we put in a tub surround with a window on the back wall and trimmed it with wood trim painted with good enamel paint. We dressed the window with slatted vinyl blinds that were 2 or 3 inches larger than the window top bottom and sides. We never had problems with the window but did replace the blinds numerous times because of mildew stains. Because I love having the window I am getting ready to do it all over again this week. This time with a new vinyl clad window trimmed with vinyl and I will use the pleated shades that can be opened from the top or bottom. Use common sense, You have to protect the window from moisture as much as possible and it must be able to dry out when it does get wet. Seal everything and keep it sealed. Good Luck.
2016-03-28 23:55:38 · answer #3 · answered by ? 4 · 0⤊ 0⤋
Make sure the wall is clean and dry.. Also, very important is to get adhesive for tub surround. Don't get the cheap stuff. It won't pay off.
2006-12-29 06:40:37 · answer #4 · answered by Anonymous · 0⤊ 0⤋
you're doing it in reverse as we would usually do it, but never the less, just see that the btm & top are sealed so the water does not get into the inside of the shower walls.
2006-12-29 06:32:43 · answer #5 · answered by ticketoride04 5 · 1⤊ 0⤋
done this...b4...a few times... make sure all is dry...simply use silicone adhesive to surround kit to adhere to walls..
2006-12-30 01:40:03 · answer #6 · answered by Anonymous · 1⤊ 0⤋
no just make sure it is dry. it is very easy.
2006-12-29 06:37:09 · answer #7 · answered by dude 5 · 1⤊ 0⤋