does anyone know why my washing machine always has water in the section where the fabric softner goes..?? The machine works fine, just don't know why this happens...
2006-12-29 03:53:25 · 7 answers · asked by leojlg2602 1 in Home & Garden ➔ Maintenance & Repairs
When the solenoid valve closes, the remaining water in the tube drains into the dispenser. It has no purpose. Just a poor design. A lot of brands do the same thing. If the valve was lower than the dispenser it woulden't happen.
2006-12-29 23:56:35 · answer #1 · answered by mountainriley 6 · 0⤊ 0⤋
Water enters the fabric softener section to flush out the softener, it then leaves a trickle of water behind to make sure there is no softener left and prevents a build up of gunge!
2006-12-29 04:04:04 · answer #2 · answered by Carrot Cruncher 5 · 1⤊ 0⤋
the water runs thru there to help distribute the fabric softener in a diluted form so the high concentration of softener won't stain clothes.
2006-12-29 04:01:41 · answer #3 · answered by Library Eyes 6 · 1⤊ 0⤋
take draw out of machine(when not use as water enters in here ) wash in sink in kitchen to clean blockage then put back in (there is an upside down U shaped unit .when you put your softener in water enters in here to flush it
into you machine to soften your washing it works by gravity
2007-01-01 04:04:36 · answer #4 · answered by Anonymous · 0⤊ 0⤋
I get this also when I put powder in the fab tray.This happens by mistake when putting the powder in .And after a wash has been done.
2006-12-29 04:26:38 · answer #5 · answered by uber-urban 2 · 1⤊ 0⤋
pull the draw out and clean all the residue out with a tooth brush
2007-01-01 09:27:23 · answer #6 · answered by The tagg master 3 · 0⤊ 0⤋
SILLY QUESTION WHEN GOD WAS HANDING OUT BRAINS DID YOU ASK FOR ATRAIN AND GOT A SLOW ONE
2007-01-01 01:55:27 · answer #7 · answered by bazbog 2 · 0⤊ 0⤋