The blades came with a pathetic "illustration" to demonstrate how to install, and I've gotten as far as the proper positioning. Hoever, I can't seem to "lock" them into place. What gives?
2006-12-28 07:31:25 · 5 answers · asked by scouseryank33 3 in Cars & Transportation ➔ Maintenance & Repairs
My wife's cousin had the same problem. The Anco blade would not click into the j-hook until the locking tab was depressed (not pulled out) which did then allow locking in place. Once you see how to do it, you will always know.
2006-12-28 09:01:41 · answer #1 · answered by db79300 4 · 0⤊ 0⤋
Anco Wiper Blades Installation
2016-11-06 20:10:17 · answer #2 · answered by Anonymous · 0⤊ 0⤋
You probably haven't pulled against the hook hard enough. It doesn't take superhuman strength (don't want you to break it), however, you should pull until you hear a click.
If that doesn't work, look for a little tab at the back of the wiper (open end of the hook), and try to push it down to lock the wiper in place.
Good luck.
2006-12-28 07:40:50 · answer #3 · answered by Anonymous · 0⤊ 0⤋
Don't forget to check the Anco packaging for a J-hook adapter. On certain models (i.e. Dodge Durango), you will need to remove the plastic sleeve and replace it with the longer one.
2013-12-02 07:46:02 · answer #4 · answered by Florence 1 · 0⤊ 0⤋
Goodyear 26 inch bought from Costco would not snap in. Even when I tried a second one from exchange. Bought RainX and it snapped right in!
2013-10-22 02:58:11 · answer #5 · answered by Anonymous · 0⤊ 0⤋