The vehicle is a 92 Explorer 4x4 with a v6. I recently changed my oil. Filled to proper level. Filled trans fluid to proper level and added a stop leak to trans fluid. In the past month I've had to add about 3-4 quarts of trans fluid to keep it at the proper level. I recently checked the engine oil and found it to be about 3-4 quarts too high.
2006-12-26 11:36:47 · 10 answers · asked by Jason K 3 in Cars & Transportation ➔ Maintenance & Repairs
There is no way for trans fluid to get into engine oil. Even if it had a modulator, it would just burn it through the cylinders. Not get into the oil.
2006-12-26 11:55:33 · answer #1 · answered by TonynNC 5 · 1⤊ 1⤋
NOT impossible! I've changed many of Module's on various vehicles. White smoke bellows from the exhaust with a distinctive smell of burning trans fluid, engine spark knocks and has reduced acceleration, checked the engine oil and wahlah...trans fluid in the oil, changed the module and POOF problem solved! I've found it more common on 6 cylinder GM's.
2014-05-12 14:54:54 · answer #2 · answered by gonein6tsec 1 · 1⤊ 0⤋
it is not accessible. optimistic the trans point can drop even nonetheless it does not finally end up in the oil pan. even a foul vacuum modulator could enable the engine to ingest the atf yet positioned it in the combustion chamber to be burned, no longer dropped into the oil pan. optimistic the oil point could seem over finished yet on lots of of the ford engines on condition that 1983, that stick replaced into marked incorrect, so even actual after an oil substitute it reads over finished on some and occasional on others.
2016-10-06 01:27:37 · answer #3 · answered by hobin 4 · 0⤊ 0⤋
It is probably the transmission modulator leaking back through because the diaphragm is shot.
2006-12-26 11:42:16 · answer #4 · answered by halfastmike 1 · 1⤊ 1⤋
i think you put transmission fluid in your engine oil by mistake.
2006-12-26 11:42:21 · answer #5 · answered by Anonymous · 1⤊ 0⤋
sounds like it could be leaking thru your radiator get a presure
check on your radiator
2006-12-26 12:02:15 · answer #6 · answered by richard w 1 · 0⤊ 0⤋
Check your rear main seal.
2006-12-26 11:44:55 · answer #7 · answered by Anonymous · 0⤊ 1⤋
Sure you put it in the right spot?
2006-12-26 11:39:43 · answer #8 · answered by Silverstang 7 · 1⤊ 0⤋
theres no way possible for that to happen i think you put it in the wrong place
2006-12-27 10:22:37 · answer #9 · answered by Anonymous · 0⤊ 1⤋
I M P O S S I B L E
2006-12-28 11:13:28 · answer #10 · answered by HowFuzzyWuzee 6 · 0⤊ 1⤋