This is a house I bought a year ago. The kitchen light on the ceiling has burned out, but there is no obvious way to remove the bowl to get at the bulb.
Normally a flush mount fixture has a bolt than you can remove that will loosen the bowl, but not this one. There are no bolts, screws, or anything else. I have tried pushing up on the bowl and trying to turn it. No luck. I am completely clueless.
2006-12-26 07:26:29 · 6 answers · asked by Lights 2 in Home & Garden ➔ Maintenance & Repairs
Grab the metal part of the fixture that is flush with the ceiling and gently pull down. It will slide down on 2 springlike wires.
.
2006-12-26 07:34:52 · answer #1 · answered by Anonymous · 0⤊ 0⤋
Don't know for sure but sometimes these fixtures are attached with a bayonet mount. You could try holding the shade and the clips and carefully turning the whole thing counterclockwise. That might release the shade.
2016-05-23 08:25:33 · answer #2 · answered by ? 4 · 0⤊ 0⤋
Put a screw driver under the edge and twist side wise, it's a spring loaded set. It will snap down with force. It goes back with force also, watch out for the fingers.
2006-12-26 08:44:29 · answer #3 · answered by cowboydoc 7 · 0⤊ 0⤋
I've seen some that were "spring-loaded", basically you just pulled them down and the spring extended. Only then could you change your bulb. Hope I've helped you out.....best of luck to you.
2006-12-26 07:31:00 · answer #4 · answered by cajunrescuemedic 6 · 0⤊ 0⤋
The trim ring will pull straight down.
2006-12-26 07:35:45 · answer #5 · answered by BUBBA~THE~POOCH 3 · 0⤊ 0⤋
the trim ring will remove by pulling downward
2006-12-26 07:41:12 · answer #6 · answered by ticketoride04 5 · 0⤊ 0⤋