English Deutsch Français Italiano Español Português 繁體中文 Bahasa Indonesia Tiếng Việt ภาษาไทย
All categories

2006-12-26 03:51:34 · 7 answers · asked by tiger171 1 in Cars & Transportation Car Makes Chevrolet

7 answers

under the exhaust crossover pipe on the driver side the car. it has two 13 mm bolts holding it on. one hole is elongated to make the replacement easier but its still a pain,

2006-12-26 06:06:16 · answer #1 · answered by riverrat17120 2 · 0 0

2000 Chevy Venture Thermostat

2016-11-03 02:21:36 · answer #2 · answered by ? 4 · 0 0

For the best answers, search on this site https://shorturl.im/awezU

I had the same problem and the repair was to change the thermostat. When the dealer took out the OLD ONE, it looked perfect. Its hard to check it out of the car and the $12.00 replacement was worth it. Now I get heat in 2 miles and the indicator goes to the middle once again. Also, I have good heat.

2016-04-04 05:14:57 · answer #3 · answered by Anonymous · 0 0

Be sure to drain the cooling system. Remove the spark plug wire harness from the thermostat bypass pipe & it should be right there under the bypass pipe.

2006-12-29 02:44:17 · answer #4 · answered by Anonymous · 0 0

Its under the exhaust cross-over pipe . look at where rad hose goes to end of intake.two bolts secure hsg to intake,only problem its a pain to get to.you would be better of to remove the exhaust pipe to gain room to remove bolts.

2006-12-26 04:04:21 · answer #5 · answered by deltech 4 · 0 0

Its under the exhaust cross-over pipe

2006-12-27 04:50:26 · answer #6 · answered by jerry 7 · 0 0

its under the crossover pipe for the exhaust . It has to be removed to change t-stat big job if you don,t know what your doin

2006-12-26 13:21:46 · answer #7 · answered by Anonymous · 0 0

fedest.com, questions and answers