A chain for a gas powered scooter?

Question

my brother in law gave me a 4 stroke gas powered scooter and i need a chain dose anyone know were i can get one in portland oregon area

Answer 1

There are kits where you can make your own chain lengths

Answer 2

Always give year, make, engine size and model # when asking questions. We need all of that info to research your question.
Contact EK Chain with that info.
http://www.ekchain.com/select.htm
Well known brand name scooters don't use chains. They have drive belts.

Answer 3

# Get a scooter with hand brakes and inflatable tires. Scooters with hand brakes have the wonderful battling power. Inflatable tires enable for the automobile to cope with rougher terrain. baby scooters such because of the fact the "razor" are no longer proper for this project, because of the fact they use no longer difficulty-free rubber wheels with pre-pressed bearings. One would additionally build a scooter physique (demands welding). # practice the chainsaw engine by ability of removing the bar and chain from the gadget. flow away something of the chainsaw intact. Leaving the motor interior the chainsaw housing makes it extra basic to attach to the scooter’s deck. Unscrew the chainsaw’s centrifugal grab from the crank shaft. the flexibility from the motor would be transmitted through sprockets and a bicycle chain. the glaring concern with this mindset is which you will in no way have the flexibility to "idle" with the engine working and the scooter table sure, and you will would desire to enhance the rear wheel off the floor to get it began. One would additionally shop the grab, and use a set that would in fantastic condition to the sprocket on the grab bell. # Bolt the different sprocket to the rear axle of the scooter. this would be extra basic mentioned than executed--intently choose your scooter understanding which you will would desire to alter the rear wheel mount, and connect the sprocket onto the rear wheel. # place the motor on the rear of the scooter platform to establish the sprockets are in-line. # Drill holes interior the direction of the platform and chainsaw motor housing so as that they'd be bolted mutually. be conscious that maximum cutting-side chainsaw housings are made up of plastic and you will would desire to be very strategic approximately the place you're attaching bolts, and the size of washers you utilize (to maintain them from in basic terms pulling interior the direction of the plastic). # Wrap the motorbike chain around the sprockets. get rid of the mandatory quantity of links so as that the chain is taut. # connect the hand accelerator to between the cope with bars. cord the hand accelerator to the ‘on and rancid’ wires on the chainsaw motor. this helps the rider to regulate whilst the engine will power the scooter.

Answer 4

Take it to a mower/saw repair shop, they can probably match the chain you need.