2 questions, HELP URGENT!!!?

Question

How can I remove the tint from my windows. I got a ticket and I have to got to court tomorrow?

Is there any website were I can post my weeding pic with my name and my wifes as a domain (e.g. Luisymaria.com) ?

Answer 1

Tips: The difficult thing about removing tint is that most film is constructed of two layers of tinted polyester. When you try to peel the film off the glass, the top layer will usually pull right off leaving the second layer behind. This second layer will not peel off, it will just flake and tear like a price tag.

Step 1:
To overcome separation between layers you must soften the adhesive so that both layers peel at the same time. This is very important, if you peel the just the top layer, you may as well just use razor blades as there is no way to peel the second layer off without picking at it for a few hours. You MUST try to peel both layers at once.

NOTE: You are more than likely to damage one or more of your defroster lines, when this happens, the cut line will not work anymore. Some cars have radio antennas mounted alongside the defrosters made of the same material. If you damage these, your radio antenna will not work! Be careful! Taking it to a tint shop to be done greatly increases the odds of saving the lines, but even a tint shop can not promise to save your lines, sometimes the film is just too far gone.

Step 2:
First, clear the window of any obstructions, like the brake light, speaker covers, etc.

Step 3:
Next cut open the garbage bag so that it will be big enough to cover the entire window. Spray some water on the outside of the back window and the lay plastic bag over the glass. Cut away excess plastic so that it is now roughly the same shape as the glass.

Step 4:
Next, lay a tarp over rear deck and seat, spray ammonia liberally on the inside of the back window. (Ammonia is very strong, I suggest you hold your breath during this step) and cover ammonia-soaked tint with the plastic bag so that it won't evaporate.

Step 5:
Park the car with rear window facing the sun for about an hour. The film should now be ready to peel.

Step 6:
When you are ready to start peeling, leave the plastic in place so the ammonia wont dry. Get the peeling started with a razor blade in a corner where there are no defroster lines. Try to peel film off in one piece. If the ammonia dries as you peel, the glue will get hard again, so spray a bit of ammonia on the area as you peel.

Step 7:
Once the film is peeled, you will need to scrub the adhesive off with ammonia and fine 0000 steel wool. Mop up scrubbed areas with paper towels before they dry. Finish up with window cleaner and paper towels.

Step 8:
Removing tint from side windows Soaking is not nessesary here. You may want to use a simple razorblade holder. Cut a notch onto the upper area of the film so that you have a piece to pull. Try to peel the film, it will probably come off in two or three pieces.

Step 9:
Spray the remaining adhesive with soapy water, and scrape the adhesive off with a razor blade, avoiding the edges of the glass to keep the blade sharp. You may need to use a few blades as they dull quickly.

Step 10:
Finish up with window cleaner and paper towels. Inspect for missed glue (it's clear and hard to see).

Answer 2

What state do you live in and how old is your vehicle? I don't think they can force you if the vehicle is older and you bought it with the tint, now if you added it yourself, then that's a problem, you'd have to have new windows put in to replace the tinted ones, you can't just remove a tint.

for a domain, you generally have to buy them, yahoo is the cheapest quality site for that, you can buy the domain for $1.99 a month and the website itself for $4.95 a month to start, so $7.00 a month isn't bad at all. You can even make a free website but it won't be your chose name above unless you have that for your yahoo id name.

Answer 3

Answer to question one: You have to get un-tinted windows. You cannot just remove them, it doesn't come off as dirt would when scrubbing soap on it. Go to your local glass company (ex. Oil Can Henrys, not Jiffy Lube, i've experienced many problems with their service).
Answer to question two: I'm no web expert, but I don't think that's possible. The photographer who took the pictures at your wedding should have he or she's own website to post their clients photos.

Answer 4

With a single sided razor blade. They sell them at hardware stores. Just start scraping you'll get the hang of it after a while (getting started is the tricky part) but you'll find your groove.
Do it from top to bottom all the way across the window.
Then do it across (right to left) the same way. That's just for streaks that might have remained. (maybe wet the window with soap and water if the blade keeps sticking).

Answer 5

1. Go to an auto body shop. They (the court) will probably give you time to get it removed.
2. Try snapfish for the wedding pictures. Weeding?

Answer 6

Take your car to mechanic. About the website???? you mean wedding(not weeding)pic right? Wasnt sure...first glance made me think it was a question bout weed. Either way wed or weed ...i have no idea. sorry. good luck!

Answer 7

Take your car to mechanic. About the website???? you mean wedding(not weeding)pic right? Wasnt sure...first glance made me think it was a question bout weed. Either way wed or weed ...i have no idea. sorry. good luck!