2006-12-21 08:29:55 · 5 answers · asked by Anonymous in Cars & Transportation ➔ Motorcycles
Underneath the meters is a bracket that is held in place by 2 nuts. Remove the nuts, then remove the meters and bracket. Underneath the meters is a plastic cover - remove it (1 screw in the center towards the rear). The bulb sockets are pushed in. Just pull them out.
2006-12-21 10:51:12 · answer #1 · answered by guardrailjim 7 · 0⤊ 0⤋
check under clocks for rubber bungs with wires going in these will be bulb holders remove them & fit new bulb,
dont know about the er5 but had & still have loads of different bikes most are like that, also i have never had to strip fairing or clocks to fit a bulb strugle yes but done it with out,
2006-12-21 17:33:54 · answer #2 · answered by quasar 6 · 0⤊ 0⤋
you will have to remove the clocks if your lucky there will be a twist type fitting if not you will have to remove the back of the clocks which should take about 5 minutes to access the bulb
will take about 30 to 45 minutes make sure you have a new bulb to hand
2006-12-21 16:35:33 · answer #3 · answered by Anonymous · 0⤊ 0⤋
you'd have to take the dashboard nacelle off which was effin hard on my honda cg125 as it holds the ignition.
2006-12-21 16:32:31 · answer #4 · answered by hellraiza15 3 · 0⤊ 1⤋
yes
2006-12-21 16:40:33 · answer #5 · answered by Anonymous · 0⤊ 0⤋