How to change a blown out Tire?

Answer 1

Call tripple A....... AAA....

Or let someone know on what ?

Example a car.... Pull over
set flashers on and check flat tire and make sure its only one
Get spare tire and jack out of the car also get lug wrench to remove lug Nuts or studs
Make sure car is off and in park...
Place jack where it shows in manual to put jack to lift that model of car...
Loosen lug nuts/studs,,, but do not remove
jack car up now
remove lug nuts/studs
remove flat tire install spare
reinstall lug nuts/studs by hand tighten by hand
lower car slowly
when spare is touching ground Tighten each lug nut/stud
start with one and go to the oppisite side and tighten that one
check again
remove jack
place flat tire and wheel in trunk put away jack and lug wrench
Clean up ??? Maybe not
Drive to gas station or auto center and get flat fixed or replaced
if its over 50 miles recheck those lug nuts make sure they are still tight...

This is the basic's for most cars and Light trucks...

Answer 2

Stay calm, do not panic
·Slowly take your foot off of the gas and let the vehicle coast to a stop.
·Do not make any sudden braking or steering actions.
·
Step 1: Make sure you are on firm level ground and away from traffic.

Step 2: Set your emergency brake and put the car in Park or 1st gear if you have a manual transmission.
Make sure the engine is turned off.

Step 3: Locate the spare tire, jack, and lug wrench. These are usually located in the trunk underneath the carpet on cars. Trucks usually have the jack and lug wrench behind the seat or under the hood, with the spare tire under the bed.

Step 4: Typically there are instructions printed on the jack or somewhere near the storage compartment or in your owners manual . Read these instructions, they will tell you where to jack the vehicle and any special steps you will need to take.

Step 5: First remove the hubcap or wheel cover. The lug wrench often has a flat end, which you can use to pry off the cover. If not, a screwdriver will work just fine.
Step 6: Before you jack the car up you will want to break loose the lug nuts. The weight of the car will keep the wheel from spinning and allow you to apply more force to the nuts. You do not want to completely remove the lug nuts yet.... just break them loose. Once the lug nut begins to move, STOP and move onto the next one. I often carry a small pipe, which will fit over the lug wrench.. Turn the lug nuts left or counter clockwise to loosen
.
Step 7: Now it's time to jack up the car. Make sure you know where the manufacturer has placed jacking points by reading the owners manual or the instructions near or on the jack. Most cars will have a reinforced lip where the jack can be placed. If you can not locate this, look for a solid portion of the frame to jack on. Make sure the jack is on firm level ground and start jacking. Take it slowly and only go as far as you need to get the wheel off.
Step 8: The wheel is off the ground . Use the wrench or your fingers to remove the nuts. Take the wheel off and set it to the side.

Step 9: Get the new wheel and put it on the car. Tighten the lug nuts as tight as you can without the wheel spinning. Don't worry about getting the nuts super tight, as you will do the final tightening when the car is off of the jack.

Step 10: Let the car down off of the jack and get your lug wrench. Tighten the lug nuts in a star pattern if there are five nuts. Start with one lug nut and skip the next one until they are all tight. If you have 4 nuts, just tighten the opposite nut from where you started and then the remaining two in any order.

Step 11: Replace your wheel cover or hubcap If your spare tire had air in it, you should be able to continue your journey.
Finally: Remember if you have a temporary spare tire (AKA doughnut) you can only drive a few miles to a service station and usually not over 50 MPH.

Answer 3

You mean off the car or off the rim..

For the former.. jack up the car.. remove the old tire and reinstall the spare.. not exactly rocket science.

For the latter, unless you have a stand and a few torsion bars, take it to a dealer and have them pull the old tire off the rim. Its not worth the scuffed knuckles or the cut fingers to try to work the tire off by hand.

Ive done one.. never again.....trust me.

Answer 4

take it off the car and use the spare,and have another tire put on the rim,and on the car,,make sure its one that's the right size for it though,good luck,