today it started by my abs light flashing off and on so then i checked to see if the outside brake lights were working and they would not come on so i checked my fuses and found 1 that was burnt into so i replaced it now my outside brake lights wont go off at all. please help i need to know what this is and how to fix it
2006-12-15 16:21:58 · 7 answers · asked by mela26 2 in Cars & Transportation ➔ Maintenance & Repairs
ok we took off the switch plug that goes to the brake light switch and the brake lights are still onshould this not cause them to go off?
2006-12-15 16:41:36 · update #1
your abs light came on due to your brake lights not working and your fuse blew probably because you brake light switch is defective also y your brake lights stay on.
REMOVAL AND INSTALLATION
Disconnect battery ground cable.
Fig. 3 Stop Light Switch Replacement
Lift locking tab, then disconnect electrical connector from switch.
Remove hairpin retainer, then slide stop light switch, pushrod, nylon washers and bushings away from pedal and remove the switch from vehicle.
Reverse procedure to install.
NOTE: Ensure stop light switch wires are of sufficient length to allow full travel of the brake pedal.
© 2006 ALLDATA LLC. All rights reserved.
Terms of Use
2006-12-15 16:29:06 · answer #1 · answered by russ G 3 · 1⤊ 0⤋
Replace the brake light switch.
2006-12-15 16:25:04 · answer #2 · answered by Anonymous · 0⤊ 0⤋
what type of automobile? on maximum imports there's a brake gentle swap grommet by using the years it falls out of it holder and could reason the brake gentle to proceed to exist. look on the drivers aspect floor you may locate the grommet. The grommet keeps the brake light fixtures off once you press the brakes the grommet is moved faraway from the brake gentle swap and the light fixtures illuminate in the back. note: the brake gentle swap is often placed up in the back of the brake pedal shaft.
2016-10-18 08:51:55 · answer #3 · answered by ? 4 · 0⤊ 0⤋
The flashing thtat your ABS light was doing is called coding. Take it to a dealership or auto tech! Remeber that brakes are your most important safety feature on your vehicle! It is best to get it in and taken care of.
2006-12-15 16:25:13 · answer #4 · answered by lynette g 2 · 0⤊ 1⤋
maybe the brake pedal switch is screwed
2006-12-15 16:24:28 · answer #5 · answered by ? 7 · 0⤊ 0⤋
when you step on your brake,a switch above the pedal is depressed.Its a plunger type.Might be stuck down.
2006-12-15 16:25:43 · answer #6 · answered by danp 3 · 0⤊ 0⤋
Take your foot off the brake. (Sorry)
2006-12-15 16:24:10 · answer #7 · answered by twicewise 3 · 0⤊ 2⤋