how to program keyless remote for 95 mazda millenia?

Question

i just got a 95 mazda , it has a remote key but its not program ,does any no how to program it . the dealership want like $100.00 to program it for me . is there a way i can do it myself.


thanks

Answer 1

1. Remove key from ignition.

2. Close all doors.

3. Open driver side door and leave open.

4. Insert key in ignition, Turn key to ON (as far as you can go without starting the engine) and OFF, Remove Key.

5. Repeat step 4 two more times, making sure you remove key each time.

6. Close and then open the driver’s door three times.

7. Buzz sound or chime should be heard at this point signaling that the vehicle is now in programming mode. If not, wait 40 seconds and return to step 1.

8. All transmitters need to be programmed at this time, including the old ones. Push any button on a transmitter two times. A buzz sound to chime should be heard at this point signaling that the vehicle has accepted the new transmitter code. Repeat for next transmitter, up to a total of three remotes (including any old remotes).

9. After all remotes are programmed, wait 15 seconds or until you hear four chimes signaling successful programming.

Answer 2

Be very careful with this car. Check the date of manufacture for your car. If it is a 1994 build, sell it and get another car. We had an August 1994 build and we dumped over $7,000 into repairs in 116K miles. It was one of the worst cars we've owned. I did some research and found out that the early 1995's were horrible.

Be careful.

Greg

Answer 3

There must be a relay field lower than the sprint on the drivers aspect. Open the distant and open the relay field(a tiny black or sparkling field). There must be numbers that you'll tournament at the same time so that they are going to be able to signal eachother. desire this helps.

Answer 4

try turning the key in the lock and clicking the opne button. if that doesn't work try it in the ignition. if that doesn't work shell out the $100.