I have an '04 Dodge Neon and the interior 'brake' light keeps flashing on and then goes right back off. This happens while I'm driving but not every time. Is it something I need to get checked out or is it just a short?
2006-12-15 02:28:26 · 12 answers · asked by truly_insightful 4 in Cars & Transportation ➔ Maintenance & Repairs
this is probably due to a low brake fluid level in the master cylinder. you should have the brakes checked for wear and any fluid leaks
2006-12-15 02:34:51 · answer #1 · answered by Anonymous · 3⤊ 0⤋
It could be air in the brake lines or low fluid as reported above. It could also be an electrical problem caused by a sort or a faulty sensor. Depending on the manufacture, not sure about Dodge, it could even be an indicator for some completely non-brake related problem. No matter what though this is something you would probably be better of getting checked out. At the very least you'll gain some piece of mind if it turns out to be nothing.
2006-12-15 02:46:23 · answer #2 · answered by detailer02 1 · 0⤊ 0⤋
If you are not experiencing any brake 'fade' then I would say it's an electrical short. Check to plug-ins at the ABS unit. While you are there look at the reservoir that holds the brake fluid, is it at the 'proper' level?
Then you can always have a certified brake mechanic check the system. Most brake shops will perform the inspection for a minimal cost, sometimes free.
In any event, unless you are a 'shade tree mechanic', your best bet is to get the brakes checked. It makes no sense to take the chance of losing your's or someone else's life.
2006-12-15 02:44:01 · answer #3 · answered by LifeRyder 4 · 0⤊ 0⤋
I would definitely check the fluid level. The light will come on if the level gets too low, usually when you are slowing down or in a turn. Some cars also let you know you have a brake light bulb out by the light coming on. Any way you look at it you have a problem, possibly as simple as a bulb burned out or as complex as a major brake problem. Please get someone qualified to check it for you before something terrible happens.
2006-12-15 03:41:47 · answer #4 · answered by 96 chevy 2 · 1⤊ 0⤋
I would'nt ignore it. Its there for a reason. It is letting you know that something needs servicing in your brakes. Either the pads are getting low, or most likely you need to check the brake fluid level...hope that helps.
2006-12-15 02:34:10 · answer #5 · answered by dewhatulike 5 · 3⤊ 0⤋
If you don't use your parking brake often, it could be a defective switch on your parking brake. It may also indicate an intermittent problem with your braking system.
Get your codes scanned to see what trouble codes might be stored. But I'm betting the switch that indicates the parking brakes posistion is loose or defective.
2006-12-15 02:34:38 · answer #6 · answered by Lemar J 6 · 1⤊ 1⤋
The ABS equipment exams the sensors every time you turn the main on. It failed one in each of them as quickly as, yet then surpassed it the subsequent time. A failing sensor or connector is probable intermittent. The equipment could have the failure saved, so everybody with a commercial grade reader can inform you what the priority became. do no longer forget approximately approximately it. it could make the ABS kick in whilst it is going to no longer or fail to kick in whilst it is going to. Bruce is suited. the two best issues that reason distinctive electric powered and sensor issues are undesirable engine to chassis grounds and undesirable ECM grounds.
2016-12-11 09:38:05 · answer #7 · answered by ? 4 · 0⤊ 0⤋
replace your brake pads or the fluid is low or the brakes are not working the right way
2006-12-15 02:50:56 · answer #8 · answered by Anonymous · 0⤊ 0⤋
Low brake fluid, because you brake pads are worn out.
2006-12-15 02:32:48 · answer #9 · answered by Mr. KnowItAll 7 · 3⤊ 0⤋
It means you have a malfunction in your brakes. Get it checked.
2006-12-15 02:56:18 · answer #10 · answered by oklatom 7 · 0⤊ 0⤋