2006-12-14 12:58:50 · 8 answers · asked by Suzi Q 2 in Cars & Transportation ➔ Maintenance & Repairs
turn ignition to run position (engine off)
push gas pedal all the way to floor 3 times within 5 seconds
Oil change light blinks a few times
start engine
turn off engine
or Reset is done by using radio
or could be done by pushing button on dash cluster until says oil life and when it says that hold down button until says 100%
I think it should be be #3, I have a friend that has a 99 montana that has how I reset that one.
2006-12-14 15:31:09 · answer #1 · answered by stealth5033 3 · 0⤊ 0⤋
I just looked it up for you.
Turn the Ignition on but engine off. Push the gas pedal Fully 3 times within 5 seconds.
Turn ignition OFF. If change oil light flashes 2 times then Oil Life monitor has been reset. If when you turn the key on , the Change Oil light comes on for 5 seconds or more, you must repeat these steps.
Straight from the tech Manual.
It has NOTHING to do with the Trip Mileage indicator !!
2006-12-14 14:28:56 · answer #2 · answered by Gordon B 5 · 0⤊ 0⤋
2000 Olds Silhouette
2016-11-14 19:23:31 · answer #3 · answered by laubersheimer 4 · 0⤊ 0⤋
Gas pedal may not clear it. Your car should have a Oil Life Percentage readout on the trip odometer. Press the button a few times until 'OIL ___ " comes up and then hold the button until it resets to 100%. If gas pedal does not work.
I am a service consultant and ex-tech at a GM (used to be Olds)
dealership, 17 years exp.
2006-12-14 13:11:28 · answer #4 · answered by kip 2 · 2⤊ 1⤋
Put oil in the car. Replace the oil pressure sending unit, this could be bad if the light never goes off. It may be easier to remove the instrument cluster and just remove the light bulb. Be sure to keep an eye on your oil level though!
2016-05-24 06:59:10 · answer #5 · answered by Anonymous · 0⤊ 0⤋
Turn the key on but don't start the motor. Wait till the "light comes on, and then push the gas pedal to the floor 3 times. It will reset.
2006-12-14 13:04:20 · answer #6 · answered by kjlh58 3 · 1⤊ 1⤋
turn the ignition on(but dont start the engine) and mash the gas pedal three times kinda fast
2006-12-14 13:02:42 · answer #7 · answered by richard m 1 · 1⤊ 0⤋
read the manual its filled with all the stuff you don't know about your car
2006-12-14 13:01:22 · answer #8 · answered by Anonymous · 0⤊ 1⤋