How do you break plexiglass?

Question

I heard that nothing can break through it, is that true?

Answer 1

# You will need a cutter, because it breaks like glass.
# Locate the width and the length using small V mark. (no need to draw lines)
# Using a rule that you hold firmly, stripe the plexiglass 4 to 5 times with a cutter. (be careful, always go in the same furrow)
# Then, always with your cutter, just start sawing the beginning and the end of the furrow.
# To break the plexiglass, use a vice, the corner of the door or simply of a table and a rule.
# Push firmly and in one go : the plexiglass will break in a deafening noise.
# For the beginners, provide you with a pair of gloves because, if the furrow is badly traced, the plexiglass can cut like glass during this operation.
# Do not forget to cut netly the plexiglass by using your cutter as if a potatoes peeler, or better by using a small gas soldering iron.
# Quickly pass flame in skew on the cut of the plexiglass without burning it and it will become round and smooth.

Answer 2

Can You Break Plexiglass

Answer 3

It depends on the thickness, but if you need to break through some, try scoring it first.

take a sharp knife ir something with a good point and make a deep line in it, try doing it several times to make a deep scar, then smash the area with a hammer

Answer 4

a pick ax, a drill, a saw. It is hard to break. But it Will break. If it is cold it might break a little easier but not by much. You pretty much need a sharp object to get it going.

Answer 5

burn it
put in in a microwave over a candle
spear it at high speed making sure it wont move when it is hit
put a big rock under it then drive over it
with more plexiglass
possibly a nalgeen bottle and a really strong person

Answer 6

I dont know if anything can, cuzz if u throw a brick through it,it'll just bounce right off.....even if u throw 2 at the same time....lmao!

Answer 7

If you exert too much pressure on it, it will start to crack (think hydraulic press).