English Deutsch Français Italiano Español Português 繁體中文 Bahasa Indonesia Tiếng Việt ภาษาไทย
All categories

8 answers

If the ramp is to be used as an accessible handicap ramp regardless if it is residential or commercial, then the maximum slope is 1 in 12 or 8% slope. If the porch is 24" high then you will need a 24' long ramp. The 1 in 8 statement in the residential code is for able bodied people to enter if you chose not to build stairs. This can be verified in the American with Disabilities Guide
(ADAAG) Section 4.8.2

2006-12-13 00:57:31 · answer #1 · answered by J H 2 · 0 0

Handicap Ramp Slope

2016-10-02 08:10:50 · answer #2 · answered by mccowen 4 · 0 0

This Site Might Help You.

RE:
What is the slope on a handicap ramp in michigan, for a private home owner?

2015-08-15 04:50:30 · answer #3 · answered by Anonymous · 0 0

Wisconsin UDC code and Internation Residence Code: Ramps shall not have a gradient greater than 1 in 8. That is one foot rise in eight feet of run. Walkways with less than 1 in 20 are not considered ramps. Don't know what Michigan code is but would suggest contacting local zoning office for more information.

Hope this helps

2006-12-12 11:58:33 · answer #4 · answered by tim r 3 · 1 0

Residential walk ramp shall have a minimum slope of one unit vertical in eight units horizontal (12.5% slope).
Handrails shall be required on at least one side on all ramps exceeding a slope of one unit vertical to 12 units horizontal
(8.33% slope).
A minimum 3 foot by 3 foot landing shall be provided:
1) At the top and bottom of ramps.
2) Where doors open on to ramps.
3) Where ramps change direction.
Note: When specified to be a handicap ramp you must check the State Amendments. Almost all States have amended the code in
compliance with the American Disabilities Act which requires graspable guard/handrails on both side and a maximum slope not to exceed one unit vertical to 12 units horizontal.
Check with your local Building Dept.

2006-12-12 13:14:59 · answer #5 · answered by Lionman 3 · 0 0

Hello,

I would start by deciding if you're looking for a permanent ramp or a portable ramp because the rules will be different for each. As a general Guideline I would recommend that you check out the following article to help you find a length. http://www.discountramps.com/articles/correct-wheelchair-ramp-length.htm

Please note that if you do go with a permanent ramp setup (modular ramp) then you should definitely contact your city for and building permits/codes that they may require.

2006-12-13 04:16:37 · answer #6 · answered by Mike N 2 · 0 0

Believe standard regulation in all 50 is 12' of run for every inch of rise,
Eg ,to rise 12" a ramp has to be 12 feet long.
Best to check local codes for clear min width , height of rail &
size & number of turns

2006-12-12 11:48:57 · answer #7 · answered by Anonymous · 0 0

For private homes ramps are considered temporary and steepness of slope is not usually enforced. safety railings are required to meet standard codes however.

2006-12-12 11:54:36 · answer #8 · answered by morris 5 · 0 0

Try Housing and Urban Development.

2006-12-12 14:02:01 · answer #9 · answered by Anonymous · 0 0

fedest.com, questions and answers