Test drove the truck and it runs flawless, has a manual trans which shifts smooth. Light has been on only a week at the most. When i first looked at the truck the check eng light was not on. Then about a week later when i went to test drive it, the light was on. Truck has 103,xxx miles and just had 100k service done by a local dealer. Only aftermarket is a Flowmaster exhaust.
2006-12-10 14:55:05 · 5 answers · asked by trillianh 1 in Cars & Transportation ➔ Maintenance & Repairs
http://dodgeram.info/Engine-Gas/OBDI/pcm_fault_code.htm
Go to this site. It has the codes, how to check them and hints and tips how to fix it.
2006-12-10 17:07:27 · answer #1 · answered by eferrell01 7 · 0⤊ 0⤋
I own a 97' dodge ram. Just like the previous answer, it being a Dodge it could be multiple things. Take to a qualified dodge dealer for check, due to some small shops not having the right ecu reading equipment. It should be fine and most dealerships will put the truck on a ecu reading system for free. Flowmasters would not have messed up system at all unless the oxygen sensors were messed with or taken out. Theres one before the converter and one about a foot behind.
2006-12-10 23:11:00 · answer #2 · answered by jtbigz_ga 2 · 0⤊ 0⤋
put the key in the ignition and turn it to the on position (do not start) on-off-on-off-on. there will be a code in the info area. look the code up online
2006-12-10 23:27:32 · answer #3 · answered by blackhawk_679 2 · 0⤊ 0⤋
it could be anything.But since she drives ok, i would think it to be a minor code like evap or something silly.Before you buy it, ask if you can take it to a shop to let them have a look see first.If They are a good dealer they will let you.
2006-12-10 23:03:01 · answer #4 · answered by tarynthegreat 2 · 0⤊ 0⤋
Have the code scanned. Autozone will do it for free.
2006-12-10 23:27:31 · answer #5 · answered by R1volta 6 · 0⤊ 0⤋