i have a 2000 honda civic ex my check engine light is on the codes are misfire on all four cylinders. i have replaced plugs wires
cap and rotor and the control module. Check engine light is still on with same code what do you think else could be wrong
2006-12-10 10:44:33 · 4 answers · asked by Justin J 1 in Cars & Transportation ➔ Car Makes ➔ Honda
You may not have anything wrong with it. If your check engine light is on, and you have replaced what you thought was the problem, you should disconnect a battery terminal for a second and then reconnect it. This will reset everything, and THEN if your check engine light is still on, you still have a problem.
2006-12-11 10:04:28 · answer #1 · answered by Anton the Nordic Bard 3 · 0⤊ 0⤋
sounds like a timing issue
are you sure that you have all the sparkplug wires correct???
firing order should be 1-3-4-2 going clockwise on the distributor
cylinder number 1 is the one closest to the drivers side of the car
2006-12-10 12:47:41 · answer #2 · answered by Mad Dog 2 · 0⤊ 0⤋
before you but all the parts on did you get the code cleared cause if you just replace the parts and not clear cod it will stay on
2006-12-10 15:26:37 · answer #3 · answered by joe s 1 · 0⤊ 0⤋
well I have a few ideas...did you install all new factory ignition components, if yes your valves maybe too tight or you mave have plugged up fuel injectors. Have you had your valves adjusted recently?
2006-12-10 10:52:58 · answer #4 · answered by ? 2 · 0⤊ 0⤋