V = I*R
voltage = current * resistance
2006-12-08 03:02:40
·
answer #1
·
answered by Andy M 3
·
0⤊
0⤋
Ohm's law is named after George Ohm, the physicist. The law describes the relationship between Voltage, Resistance and Current in an a simple electrical circuit. It's written as Voltage (in Volts) = Current (in Amps) x Resistance (in Ohms)
In simple terms, if a voltage (pressure to move electrons) of 1 volt is applied to a circuit with a 1 Ohm of resistance, a flow of 1 amp of current will result. Again, this is for a simple Direct Current (DC) circuit... A/C circuits are a bit more complex.
2006-12-08 11:11:15
·
answer #2
·
answered by dbindakota 1
·
0⤊
0⤋
OHMS LAW states that -
As long as the physical state of the conductor remains the same, the current flowing thru the conductor bears a constant ratio to the potential difference applied to it.
I = c V
c is constant of proportionality
It is the conductance of conductor
It is modified as
V = I R
R is resistance to flow of current.
The first part of stmt is necessary because the resistance changes with cange in temperature ,length,area,volume and other physical quantities.
If R remains constant,the graph of p.d. versus current is linear.
Hope this much helps!!!
2006-12-08 11:21:59
·
answer #3
·
answered by amudwar 3
·
0⤊
0⤋
Ohm's law defines the relationship between voltage and current in terms of resistance. E=I*R (Voltage equal current multiplied by resistance). Of course, you do know algebra to solve for any unknown right? I=E/R and R=E/I
2006-12-08 11:12:46
·
answer #4
·
answered by EE dude 5
·
0⤊
0⤋
Voltage = Current * Resistance,
where units are:
Voltage - volts
Currenct - amps
Resistance - ohms
2006-12-08 11:05:03
·
answer #5
·
answered by Boatman 3
·
0⤊
0⤋
The Ohms law is like this Ohms, R is a streanght line on graph with Volt,v when that are not other Physical that change like leanght, temperture...
(Sorry, my English are not good)
2006-12-08 11:21:49
·
answer #6
·
answered by Alrin Lee 1
·
0⤊
0⤋
The voltage across a resistor is the product of its resistance and the current through it, E = IR. It's the most basic relationship between voltage and current, and applies to a purely resistive load. The relationship is different for other passive devices like capacitors and inductors, and for active devices like transistors.
2006-12-08 11:08:08
·
answer #7
·
answered by Frank N 7
·
0⤊
0⤋
ohm's law states that,
I is proportional to v (at constant temperature).
also the constant of proportionality is designated as R(resistance).
and R=ml/(n*(e to the power2)*relaxation time);
relaxation time is not urs but between the collisions.
l-length
n-no.of electronsper unit volume
2006-12-08 13:35:00
·
answer #8
·
answered by physics 2
·
0⤊
0⤋
voltage=current * resistance, in an ideal conductor
2006-12-08 11:06:23
·
answer #9
·
answered by odell 2
·
0⤊
0⤋