Do you need to pull the top off? How do you do this?
2006-12-06 11:27:04 · 5 answers · asked by Anonymous in Home & Garden ➔ Maintenance & Repairs
Try this link ....
http://www.repairclinic.com/ge-dryer-parts-gg.htm
2006-12-06 11:35:48 · answer #1 · answered by Zippy 2 · 1⤊ 0⤋
straightforward restoration. Open the front door do away with 4 Phillips head screws conserving the right to the front lip. advance the right and help it so it wont fall. on the backside of the front section close to the floor you will locate one 5/sixteen sheet steel screw on the two section. Loosen yet do no longer do away with those screws. back on the right, look interior the place the front meets the main cabinet. there is yet another 5/sixteen" screw on the two section.do away with them. the front will now shy away and carry off the backside screws. Slide the hot belt(Grooved section against the drum)around the drum. you will see the ware mark on the drum to know a thank you to place it. placed the front back on. tighten screws. placed the right down and attach with the 4 phillip screws. do away with the rear conceal on the backside. do no longer THROW AWAY THE BRICK interior. Take the belt popping out of your left and placed the back element of the belt over the right of the plastic pulley(Spring rigidity into the pulley arm till the belt will attain around the motor pulley) slowly launch the pulley to soak up the slack interior the belt. placed the back on. initiate the dryer. Have a lager. delight in the interest. The section # you opt for is: WE12X82P stress belt
2016-10-14 04:20:28 · answer #2 · answered by tonini 4 · 0⤊ 0⤋
the top of the dryer should be on a hinge and you should be able to pry the front open, sorta like a can lid. you should be able to look down inside the dryer and see the drum. You may need some help. You'll have to pull the front panel off. you may have to screw it out or pop it out, be careful not to damage the clips. you should have access to the front of the drum. Wrap the new belt over the drum and onto the motor underneath. then put it back together again. good luck
2006-12-06 11:45:59 · answer #3 · answered by Lena 2 · 0⤊ 1⤋
You can do it from the back. Just remove the back cover and there you are
2006-12-06 11:32:14 · answer #4 · answered by aussie 6 · 0⤊ 1⤋
just go to partselect.com and input your mak and model pretty self explanatory. they will show you how to change it.
2006-12-06 11:55:41 · answer #5 · answered by sapachedog 1 · 0⤊ 0⤋