My car starts, then makes a high pitched noise, the putts, and dies.?

Question

Its a 03 taurus.
I left work yesterday and the car started fine, as it was warming up, id say 10 seconds after starting it, it died.
I tried to start it again and it made a high pitched squeeling noise for about 3 seconds and the car died. I tried a few times, so I just left my car at work
It was a really cold night so I figured it was just too cold.
I tried again this morning and the same thing. The car ran after I revved it up a few times but I dont know if its okay to drive. The check engine light is also on now.
Never had a car problem with this vehicle before....what could the problem be???

Answer 1

That is not good. Sounds like something seized up. the high pitched squealing noise you're hearing is a belt rubbing across something that doesn't wanna turn. Could be your AC pump, Alternator, Power Steering, but something on your pulleys seized up. You might have broke it loose by revving it but the problem will come back. Take it striaght into your service department. It can easily happen on the road if you continue to drive it.

EDIT: I've had it happen before on my honda when my alternator seized up. It will cause the car to dog down and stall on an idle, if you try and run it you will smoke your belts. Take it in ASAP if you dont know how to work on your vehicle.

Answer 2

Sounds like you have a pulley locked up. One of the pulleys for the belt arent turning. The noise you hear is the sound of the belts being pulled across a stationary pulley. Dont drive it even if you get it started cause it wont take long before the belt is going to heat up, melt, and break. You need to remove the belt and find out which pulley isnt moving. Or you could get it started for a minute then shut it off and feel for which pulley is extremely hot from friction. Hope that helps. Good Luck!!!

Answer 3

perhaps the brake pads or discs are finished and the brake piston is going too a techniques that it does not go back alot, causing the pad to nonetheless keep in touch with the disc and making it grind. Now once you prepare the brakes it stop making the grinding sound because of stress. each and every so often rust on the disc can sound like grinding somewhat if the replaced into not pushed for a lengthy time period. yet when this isn't the case, then examine the pads or disc, of route it must be a lot less demanding to assert if i replaced into searching on the vehicle.

Answer 4

Many times the high pitched noise will be issues with the belts - have those checked and no I would not recommend driving the car at least not for any distance.

Good Luck