remove the battery and the housing, if possible even the keypad and let it totally dry first before trying to use it. when i got my cp wet, i used a blowdryer to make sure it was totally dry.
2006-11-29 11:41:38
·
answer #1
·
answered by Bubuchachum 6
·
1⤊
0⤋
I'm assuming it is off now. If it is not, turn off and remove the battery. Let dry at least a day and it should work. Also if possible take to a service center to have them open it and clean it out since it got wet. They have a chemical they use that helps so the contacts don't corrode together and cause your phone to start doing wierd things.
2006-11-29 11:41:53
·
answer #2
·
answered by Liz 4
·
1⤊
0⤋
I drop my cell phone in the toilet a couple weeks back you have to take the battery out and let it air dry probaly for a day but could be a couple of hours if you put it in front of the A/C or a fan.
2006-11-29 11:41:10
·
answer #3
·
answered by redbone 1
·
0⤊
0⤋
I dropped mine in the washer, and then when it came out it worked, but the inside screen was blurry, the inside one had small water drops
the water drops evaporated from the outer screen, but the inner one went blank, so i have to get a new one....
i asked a similar question about 2 wseeks ago
2006-11-29 11:40:43
·
answer #4
·
answered by Anonymous
·
0⤊
0⤋
Whatever you do, don't turn it on. You could short it out.
Take the battery out and let it dry for at least a couple of days. It should work again. My friend ran hers through the washer in her pants pocket, let it dry out and it worked fine.
Good luck!
2006-11-29 11:43:14
·
answer #5
·
answered by Sherral 3
·
0⤊
0⤋
open it up & take off the sell and take the battry out and use a blow bryer to dry it out then leave if for say 2hrs and try puting the battry bck in n c f it wrks f it doesnt u could bring it to one a those phone shops to c f they can help
2006-11-29 11:47:05
·
answer #6
·
answered by Nastassia T 2
·
0⤊
0⤋
1. Remove the battery
2. Dry the phone
3. Let it sit
4. Actively dry
2006-11-29 11:42:40
·
answer #7
·
answered by garymdmd 1
·
0⤊
0⤋
Take the battery out, if you are too paranoid dry it for a week or wadever, and make sure the sync is properly positioned.
2006-11-29 11:41:44
·
answer #8
·
answered by hugh c 2
·
0⤊
0⤋
you can take off the battery and let it dry out, i think you can take a hair dryer and blow the keypad, but not on hot cause i think that might screw it up, and once you get it dry put the battery back in and it should work
2006-11-29 11:40:20
·
answer #9
·
answered by littlehey5 3
·
0⤊
0⤋
one might not beleive in these, but, I tried and it worked!
remove battery. find something for your phone to fit in one end, and connect the other to a vacuum cleaner,s hose. keep vacuum cleaner 'on' for a while.
this method is better than to open the entire phone case, or the blow air method.
2006-11-29 12:31:34
·
answer #10
·
answered by Anonymous
·
0⤊
0⤋