what is the thing that use for cleaning the soldering iron after soldering.?

Question

what is the thing that use for cleaning the soldering iron after soldering.

I saw my friends used it; the stuffs look brown. When the soldering iron touch it, it smells good.

What is that thing called?

Answer 1

Flux is made from pine pitch, dissolved in alcohol.

Answer 2

enable your iron arise to temperature. If there is a few black crud on it, gently brush it off(small cord brush). then contact it to the soldering cord to soften adequate to coat it plus a touch extra. This little bit of further will be transferred on your paintings piece. get yet another drop on the iron and move it to a similar workpiece if it desires extra,or to the subsequent paintings piece. in the experience that your paintings piece is vivid clean and look at were given it pre fluxed, you do not ought to easily contact the iron to it, absolutely contact it with the drop of solder this can warmth the workpiece causing the solder to bypass. this technique keeps the iron freshly tinned each and every time you solder a chunk. once you ought to lay the iron down for 2 or 3 minutes to practice the subsequent piece, brush it and proceed as earlier. after a at the same time as the black crud will kind back. in simple terms brush it off and re-tin.

Answer 3

It is called "flux" and it is used to improve the quality of the soldered joint not for general iron cleaning. Cleaning is mostly done with a damp sponge.

Answer 4

Several things are used, including a damp sponge. But what you describe sounds like rosin, commonly used as a soldering flux.

Answer 5

it is probably called FLUX a liquid that is used to assist in a good solder joint .. also can clean pretty well

Answer 6

a wet sponge or you can use sand paper