English Deutsch Français Italiano Español Português 繁體中文 Bahasa Indonesia Tiếng Việt ภาษาไทย
All categories

My printer keeps coming up with an alarm say "printer jam" even though there's no such thing...any ideas?

Paper type is HP Premium Photo.

I fiddle with the buttons, pull the power chord, get one print, then the alarm comes back...

Thanks

2006-11-27 03:26:35 · 3 answers · asked by MollieGizmo 1 in Computers & Internet Hardware Printers

3 answers

In the back there should be a removable compartment. Try taking it off and see if there is any paper jammed in there.
E

2006-11-27 03:47:14 · answer #1 · answered by Elaine B 6 · 0 0

the glaring answer, of route, is to scrub the paper. in case you've tried that already, your issue ought to nicely be led to with the help of a few numerous issues. HP printers hit upon jams with sensors that hit upon the presence of paper at numerous factors contained in the print route. at the same time as the print cycle starts, the printer is conventional with how a lot time it ought to take for the paper to bypass each and every sensor. If the paper takes too lengthy to achieve a sensor, or if a sensor detects paper at the same time as there must be none, the printer throws an blunders. this signifies that "paper jam" blunders must be led to with the help of paper being not on time, paper catching contained in the route, an blunders in a sensor, or an blunders contained in the circuit board that reads the sensor. i ought to attempt some issues to unravel this: a million) ascertain that the paper in correct loaded contained in the paper tray and the sizing classes are properly set. this can restore ninety 9% of delay blunders. 2) verify ALL get entry to doors for the presence of paper. 3) Unplug the printer from wall skill and attempt to push a stiff piece of paper (like card-inventory or a manila folder) with the help of the paper route. this can clean out any paper scraps that ought to nicely be trapped in a community you may't see. Be tender. The 3320 isn't a superb gadget. If those issues do not paintings, you'll ought to move on to dismantling the gadget to interchange sensors or forums. If this is lower than assure, carry it in for upkeep. If not, chuck it and get a clean one. New aspects ought to cost almost as a lot as a clean printer.

2016-11-27 01:38:10 · answer #2 · answered by ? 4 · 0 0

You'll also get paper jam if the rollers cannot "pick up" the paper and pull it into the printer.

2006-11-27 04:44:55 · answer #3 · answered by Kasey C 7 · 0 0

fedest.com, questions and answers