I have the cord from the camera connecting to the usb port and it still tells me there is no connection. I also have the camera on and in playback i don't know what to try next. Help me please!
2006-11-26 04:05:00 · 7 answers · asked by angelwings 2 in Computers & Internet ➔ Other - Computers
Sometimes just wiggling the cord gently can help your compter recognize it, otherwise just keep removing it and reinserting, the computer will find it.
Make sure your usb ports aren't full of dust too
2006-11-26 04:08:40 · answer #1 · answered by Anonymous · 0⤊ 0⤋
You need to have your camera set to playback mode, Just like you were viewing the photos on the small lcd screen. Once in this mode is sends a signale through the usb cable and is detected by xp
2006-11-26 04:09:59 · answer #2 · answered by Fremen 6 · 0⤊ 0⤋
there are too many things that can cause this.....depends on so many things............without knowing the camera or the system you're using I would suggest...........turning off the computer.....plug in the camera and turn it on........then reboot the computer.
If after a minute or two after the reboot is complete you still don't get a message pop on the desk top open "my computer" look at the bottom of the list of appliances and if the camera or a strange hard drive are shown click on it to open the download.
If there is nothing there, go to the help section of the camera's manufacturer's web site and ask there..........don't forget to tell them the make and model of your computer with the type of operating system) and camera make and model..........they are all different.
2006-11-26 04:18:49 · answer #3 · answered by Anonymous · 0⤊ 0⤋
Your computer should tell you new device found. If it doesn't I suggest you leave it connected and reboot. Then if it still doesn't recognize the disk try going to computer icon and look for connected disks. You may need a install disk for your OS to find the hd.Hope this helps.
2006-11-26 04:15:20 · answer #4 · answered by hillcountrysb 2 · 0⤊ 0⤋
It might need to be off playback to work
If that still doesn't work, restart your computer
If that still doesn't work, try switching your cameras batteries
2006-11-26 04:13:13 · answer #5 · answered by Anonymous 2 · 0⤊ 0⤋
With camera on and connected, go to control panel, install new hardware and see if it will pick up.
Then try the camera and scanner wizard.
2006-11-26 04:10:48 · answer #6 · answered by Say What? 5 · 0⤊ 0⤋
you might need a card reader.. go to wal-mart.. if software did come with your camera .. card reader is your best bet..
2006-11-26 04:10:17 · answer #7 · answered by timothy4love69 2 · 0⤊ 0⤋