My daughter dropped her iron on the carpet and now the carpet has a iron burn printed in it, how do i repair?

Question

this. it is in the middle of her floor and her room is right next to our dining room so when we have guest over they will see it unless we close the door.

Answer 1

try scrubbing first,if that does not work and if it not too deep take a pair of scissors and cut the burnt part off

Answer 2

first RIP the carpet out of the whole house an get wood floors cause wood floors are better! other than that if you had a left over piece of carpet from where they did the carpeting u could cut the iron burn part out and cut the spare piece to fit the burn an glue it or something nack into that area an u will never tell!

Answer 3

First you cut the burned carpet in one piece then using that piece as a pattern to cut a piece of the new carpet go purchase a piece of carpet tape put lay it down to fill the hole in the carpet then place the new piece in the hole place apiece of old smooth old cloth on top of the whole thing and iron it on .be sure you set the iron on the setting that your carpet is made of ,like cotton if it is cotton and so on good luck if your not sure try a small piece on top of your ironing Bord for you to git the hang of it..PS Be sure you put the glue part of the tape facing you up..

Answer 4

Cut or scrap the burnt ends off. Then gather fibers from the whole bedroom area by snipping a little here and there or combing a few fibers out here and there. Where the burnt area was use carpet adhesive and the fibers you scraped from the rest of the carpet to conceal it.

Answer 5

Good grief lady: If your good enough you can cut it out and piece another one in but, I'm guessing since you've come on here your not, right? so, call your nearest carpet repair place and get them out. Be ready to pay the price.

Answer 6

cut it out and buy a piece to match or cover it up