can you tell me what to plug & what needs to breath? THANKS !
2006-11-14 14:49:19 · 4 answers · asked by Anonymous in Cars & Transportation ➔ Motorcycles
I believe all that you would have to do is pull the oil tank and plug the line, and of course start using pre-mixed gas. There may be a hose from the pump to the carb/manifold that you may want to disconnect and plug also. However, pre-mixing is a pain in the a--
why would you want to change over???
GB
2006-11-14 15:21:22 · answer #1 · answered by Anonymous · 1⤊ 1⤋
Don't do that!
There is absolutely no reason to wreck a bike by doing so. You didn't even ask about what changes to the carb jets you need to make. If you don't change the jets you are running the bike lean, because the oil in the premix displaces some of the gas. I have a 30 year old Yamaha with the same type oil injection in it, and it has never given me a problem I have only once had to adjust the cable other than that I kept it filled it with oil.
Again don't do that. leave it alone you are not an engineer.
2006-11-17 14:44:53 · answer #2 · answered by knujefp 4 · 0⤊ 1⤋
When they say "plug the line" - The hose going from the oil pump to the carb. Either block that line, or put a plug "on the carb" where the line goes in. You don't want any air getting into the carb.
2006-11-15 10:07:11 · answer #3 · answered by guardrailjim 7 · 1⤊ 1⤋
george is right just pull the tank and plug the line pre-mix your fuel its alot safer than relying soely on the oil injection
2006-11-15 00:52:58 · answer #4 · answered by skip75 2 · 0⤊ 1⤋