new plugs, dist. cap, button, changed main relay still no fire to plugs, no fule, yes theres gas in it, any ideas?
2006-11-12 07:03:43 · 2 answers · asked by blackharleylowrider 1 in Cars & Transportation ➔ Maintenance & Repairs
if you have no fire/spark have your ignition module tested. if thats not the problem have your pick-up coil checked.your problem could be one or both of these components.
2006-11-12 08:34:27 · answer #1 · answered by Daryl C 3 · 1⤊ 0⤋
You didn't mention if you did all these work before the engine failed or after, if it was done before engine failure, then you must check your work, make sure everything is installed correctly. Ok first you must determine if there is spark at the plugs, if there is spark, then you must check the fuel rail if there is fuel pressure when the key is on, if you cannot tell, get a can of sure start (ether) and spray into the intake, do not spray too much you don't want back firing, just a one second squrit and start the car, if it turns over couple times and quits, it may be fuel system related, so check your fuel pump, fuel filter, relays, fuses. If all is good, then you may want to take it to the dealer where they can scan the computer and find out if there is a computer fault (very rarely happens)
2006-11-12 07:18:45 · answer #2 · answered by markie 3 · 0⤊ 0⤋