I have a 51 plate Fiat Punto. Water is coming up from the fluid container but is only trickling when it gets to end before the nozzles. Thanks!
2006-11-12 00:13:41 · 12 answers · asked by hajane 1 in Cars & Transportation ➔ Maintenance & Repairs
Clean the washer jets out with a needle or a stiff piece of wire, also check and top up the washer bottle as it may be nearly empty.
2006-11-12 00:25:33 · answer #1 · answered by Goofy Goofer Goof Goof Goof ! 6 · 2⤊ 0⤋
Hi >
I agree with most of the above - so stick a sewing pin in the bonnet nozzles, and give them a wiggle.
Thet are probably blocked up a bit.
Failing that, take the coonecting hose off and press the button.
Does it p*ss out ? If not, then the pump may have passed the sell-by date. - new one.
Of course, if there is little or no watery stuff in the feeder bottle ....
Well there you go.
All the best with it.
Bob.
2006-11-12 02:44:22 · answer #2 · answered by Bob the Boat 6 · 0⤊ 0⤋
the best way is to take nozzles off and suck the blockage out from the end that connects to the nozzles(with your mouth) or take them to garage forcourt and take the pipes off and give them a blast with the tyre inflator (reverse to the flow). while the pipes are disconnected switch the washers on to get rid of dirt in the pipes!
2006-11-12 02:11:38 · answer #3 · answered by chwinc 1 · 0⤊ 0⤋
Check the hoses and leads from the water refil and check the nozzles arnt blocked from limescale from tap water. Try using readymix windscreen washer as this wont have limescale in it.
2006-11-12 01:13:09 · answer #4 · answered by ricerfuel 3 · 0⤊ 0⤋
Your washer jets are blocked. Take the hose off the inside take the jets out and blow them out with an airline in the opposite direction that the ware would go. Then refit them and adjust them with a pin that should do the job.
2006-11-13 05:07:05 · answer #5 · answered by stewart 873 3 · 0⤊ 0⤋
possible blockage at nossel end , two ways two clear one uder the bonnet youll see a clear thin hose running up to the nossel disconect and clean with detergent,second way at the nossel end use a small pin and put in holes see if that works
2006-11-12 01:49:08 · answer #6 · answered by carol.pain1 1 · 1⤊ 0⤋
Your Fiat needs Viagra
2006-11-12 01:41:18 · answer #7 · answered by Anonymous · 0⤊ 1⤋
the nozzles on the bonnet are blocked.......clear them out with a pin or needle!
2006-11-12 00:52:43 · answer #8 · answered by petuliapeculiar 2 · 1⤊ 0⤋
jets blocked try pushing a needle into the jets to clear them
2006-11-12 00:18:13 · answer #9 · answered by 808fl 5 · 2⤊ 0⤋
Make sure the hoses aren't kinked when you close the hood, too.
2006-11-12 00:42:19 · answer #10 · answered by Anonymous · 0⤊ 0⤋