2006-11-11 20:23:57 · 9 answers · asked by Anonymous in Cars & Transportation ➔ Maintenance & Repairs
As every one else says they are very cheep, but if you don't want to buy one then try heating it slowly with the tip of a prefrebly orange flame, beacuse you don't want it to burn, use a match. Once it is hot, bend it very so slowly once it is in position cool it with some water.
Good luck!
Hope this helps!
Merry Christmas!
2006-11-11 20:38:16 · answer #1 · answered by Deaks 2 · 1⤊ 0⤋
I dont think you can, If it is the telescoping type, they are made of cylindrical hollow units that is meant to fit into the each other. If it is bent, it is prety much toast. Either leave it bent or buy a new one. They are not expensive at all.
2006-11-12 04:27:51 · answer #2 · answered by QuiteNewHere 7 · 2⤊ 0⤋
If it is not badly kinked you can try feeding back into it self by hand pushing it at the base as close to the fender as possible remember though little bites at a time , but don't try bending it. it will just snap clean if you do .
2006-11-12 04:31:52 · answer #3 · answered by slick 4 · 1⤊ 0⤋
most ariels these days screw on so the are easier to remove in a car wash etc. either buy a new one or go to ur local scrap yard and aquire one there!
2006-11-12 04:33:49 · answer #4 · answered by Wobs 3 · 1⤊ 0⤋
If there's a kink in it it will already've lost it's strength and will probably break if you try to straighten It, sorry.
2006-11-12 15:05:20 · answer #5 · answered by Bandit600 5 · 1⤊ 0⤋
Very hard to do. Warm it up bend very slowly. Good luck.
2006-11-12 04:28:27 · answer #6 · answered by ? 4 · 1⤊ 0⤋
Get it some therapy and stop letting it go to gay clubs.
2006-11-12 04:39:25 · answer #7 · answered by Anonymous · 1⤊ 0⤋
Hey, dude, stop playing with your antenna!
2006-11-12 04:27:05 · answer #8 · answered by Brian 3 · 2⤊ 0⤋
buy a new one, not expensive,,, cheapskate
2006-11-12 04:26:14 · answer #9 · answered by Anonymous · 2⤊ 0⤋