can tile be installed on top of existing tile on bathroom floor?

Answer 1

only if you want the new tile to crack and break due to flex and non adhesion, or proper adhesion, i know it's alot of work and more expense to properly remove old, and re-prepare base surface (1.5 inch sub floor level thickness minimal) for new flooring , but it will last longer with less problems and cost less in the long run, due to not having to repair or replace and do properly as should have been done in first place.

Answer 2

Actually you can install new tile over existing tiles but then your in for a major headache... what i would suggest is (1)tear out the existing tile (2) make sure all sub floor boards are secure by running screws into the sub flooring (3) buys sheets of cement board from local home repair depot >> screw that down over sub flooring then your ready to use quik crete cement working in small areas to lay down new tiles...when finished with all the tile laying then let sit for 24 hrs before using grout for filling between the tile edges

Answer 3

You could lay the tile on top of the old but it is probably going to cause huge problems in the near future. Just tear up the old tile and start fresh. You will be much more satisfied with the result. Besides, tearing up the old tile is far less time consuming than preparing it to become the new base.

Answer 4

ok, I study particularly some stable solutions there. I too am against putting tile on tile. in spite of the undeniable fact that, i can't say it can't be completed. the only factor that i did no longer see suggested replaced into the top it is going to upload to the floor. you will % a leveling compound and tile adhesive below the tile. So what's that, an extra 3/8"+ to the top of the floor? Take that under consideration and then seem on the doors interior the bathing room. If the door will nonetheless swing with the further top and you % to diminish that corner, via all potential do. yet I do agree that the 1st layer of tile would desire to be in remarkable difficulty in the previous you do it. notwithstanding if it somewhat is unfastened, cracked, notwithstanding the comparable will ensue to the tile on precise of it.

Answer 5

Yes, but it's a half-way job. Your tiles will end up cracking eventually, then you'll have to do it the right way anyway. Remove the toilet and sink/vanity, pull up the vinyl, set your saw to the approximately depth of the backerboard and cut an X. Then use a pry bar to pull up the floor and the nails.

Use hardy board as a new backerboard.

It's more work than the guy at the department store told you (I just finished ripping mine up), but the results are worth it.

Answer 6

Absolutely not. It will crack and break. Rip up the new tile, install hardi-board, or wonder board. Then re-tile. You will get a nice job that will last. Don't be lazy, it will cost you more work in the long run.

Answer 7

Yes.
Got a cement specifically for that purpose at a home center.
Just needed a thicker wax ring for the toilet because of thickness
of new tile

Answer 8

For the size of a bathroom floor I would remove the old flooring and start fresh.

Answer 9

i am no expert st DIY jobs.but even i can tell you the answer to this one, i am sure you don.t want a shoddy job but as near a professional result as possible,then lift out & start from scratch

Answer 10

no no no