English Deutsch Français Italiano Español Português 繁體中文 Bahasa Indonesia Tiếng Việt ภาษาไทย
All categories

would it cost alot to make

2006-11-06 12:30:58 · 6 answers · asked by Anonymous in Cars & Transportation Car Makes Other - Car Makes

6 answers

I wouldn't bother, it's a heavy car.

2006-11-06 12:33:20 · answer #1 · answered by mad_mav70 6 · 0 0

yes and no

i would pull the body off the frame of a 3/4 ton or 1 ton truck and do it though the frames are stronger than on the lincoln

if you end up doing it have a cage built or learn to weld as though your life is counting on it, becouse you will need it. for the seat it will have to be in the middle of the frame over the driveshaft for safty you need something covering the tranny and the driveshaft incase there tranny blows apart or a bad u- joint and i have seen it then blow apart and cut work boots apart with the floor boards in the cars. as for steering, you will need to relocate it to the middle, run a shaft out of the gear box with a slider and u- joints to the cage, then a chain like a motercycle has (and sprockets connecting) to the middle with a shaft and quick realese steering wheel

as for brakes haha ya i dont give all the answers away

2006-11-07 05:22:47 · answer #2 · answered by tude 2 · 0 0

I believe the answer you are looking for is, you can certianly try but throw caution to the wind almost all dune buggies are made of the old 70's VW bugs. That's why you don't see many of them around.

2006-11-06 21:50:03 · answer #3 · answered by chrisrock_horndog 1 · 0 0

Yes you can and very inexpensively if you do all the work yourself.Biggest cost would be the roll cage.

2006-11-07 03:46:49 · answer #4 · answered by want2wild 5 · 0 0

No. you need short wheelbase and very little weight.

2006-11-06 20:45:35 · answer #5 · answered by Trump 2020 7 · 0 0

why not ...for the cost it depends what u need

2006-11-06 20:33:27 · answer #6 · answered by acierman2006 4 · 0 0

fedest.com, questions and answers