how to solve the virtual memory error?

Question

I have received "Virtual Memory low"

Answer 1

The paging file (Pagefile.sys) is a hidden file on your computer's hard disk that Windows XP uses as if it were random access memory (RAM). The paging file and physical memory comprise virtual memory. By default, Windows stores the paging file on the boot partition (the partition that contains the operating system and its support files). The default, or recommended, paging file size is equal to 1.5 times the total amount of RAM. This article discusses how you can configure the paging file for system optimization and recovery.

To enhance performance, move the paging file to a different partition. When the paging file is on the boot partition, Windows must perform disk reading and writing requests on both the system folder and the paging file. When the paging file is moved to a different partition, there is less competition between reading and writing requests.

However, if you completely remove the paging file from the boot partition, Windows cannot create a dump file (Memory.dmp) in which to write debugging information in the event that a kernel mode STOP error message occurs. This can lead to extended downtime if a debug procedure is necessary to troubleshoot the STOP error message.

The optimal solution is to create one paging file that is, by default, stored on the boot partition, and then create one paging file on another, less frequently accessed partition. Additionally, it is optimal to create the second paging file so that it exists on its own partition, with no data or operating-system-specific files. By design, Windows uses the paging file on the less frequently accessed partition over the paging file on the more heavily accessed boot partition. An internal algorithm is used to determine which paging file to use for virtual memory management.

When you place a paging file on its own partition, the paging file does not become fragmented, and this counts as another definite advantage. If a paging file resides on a partition that contains other data, it may experience fragmentation as it expands to satisfy the extra virtual memory that is required. An unfragmented paging file leads to faster virtual memory access and greater likelihood of a dump-file capture that is free of significant errors.

If you follow the preceding recommendations, you meet the following paging file configuration goals for optimization and recovery:

The system is properly configured to capture a Memory.dmp file if the computer experiences a kernel mode STOP error.
-and-
The paging file on the less frequently accessed partition is used most often because it is on a partition that is least busy.


NOTE : If your computer contains multiple hard disks, you can also create a paging file for each hard disk. When information is distributed across multiple paging files, the hard disk controller can simultaneously read from and write to multiple hard disks. As a result, system performance is enhanced.
visit:
http://www.rosecitysoftware.com/reg1aid/as-promo.html

Answer 2

Reduce the amount of running programs at one time or buy more RAM.... Do not change your virtual memory size like stated below. it will not solve anything just make things a little worse. it would just make the message go away not solve anything

Answer 3

You need to stop some programs to free some memory.

Answer 4

digital reminiscence is area allotted on your puzzling pressure for those situations that your actual reminiscence (RAM) isn't adequate. to boost the quantity of digital reminiscence visit regulate Panel > equipment > stepped ahead > performance > Settings > stepped ahead > digital reminiscence "replace" > custom length > adjust as needed. a million.5 situations your actual RAM is a good minimum and three situations your actual reminiscence in MB is nice on your optimal.

Answer 5

right click my computer,properties,advanced ,settings,advanced,virtural memory,change ,type in 1024 both boxes,set apply,ok