light goes off at higher idle(about 1,000 rpm but comes back on at higher revs.
2006-11-05 16:16:29 · 6 answers · asked by ozziebastard69 1 in Cars & Transportation ➔ Motorcycles
check the wiring to the oil light sending unit , and the sending unit itself, sounds like maybe its an electrical problem, the only way to be sure though is to check the oil pressure with a quality oil pressure gage. dont run the engine untill you know.
2006-11-05 23:32:01 · answer #1 · answered by robert s 1 · 0⤊ 0⤋
Yes have the oil pressure checked with a known good gauge.Do not trust a sending unit.
2006-11-06 00:07:05 · answer #2 · answered by gdwrnch40 6 · 0⤊ 0⤋
if THE OIL LEVAL IS OK AND THE BIKE IS NOT MAKING ANY NOISE THEN YOU HAVE A DEFECTIVE OIL SENDING UNIT.
IT IS CONNECTED BY 1 WIRE AND IT IS POSSABLE THE WIRE HAS BROKEN OR COME OFF. THIS WILL MAKE THE LIGHT STAY ON .
LOCATE THE PRESSURE SWITCH AND EATHER RECONNECT THE WIRE, REPAIR THE WIRE OR REPLACE THE SENDING UNIT.
2006-11-05 16:21:42 · answer #3 · answered by goldwing127959 6 · 1⤊ 0⤋
if the mild replaced into no longer on till now u replaced the gasket then u would have obstructed the oil passage to the oil pump whilst u did the restoration, eliminate the pan lower back and verify for conceivable blockage, if u didnt replace or sparkling the reveal screen then u could accomplish that now. low oil tension is your engines worst enemy, power the vehicle as low as conceivable till u treatment the placement
2016-12-17 04:56:31 · answer #4 · answered by Anonymous · 0⤊ 0⤋
Simple, just go to HD shop and have the sending unit replaced while you wait.
2006-11-05 17:50:44 · answer #5 · answered by Anonymous · 0⤊ 0⤋
Easy fix - sell the pos and buy a BMW
2006-11-06 10:51:50 · answer #6 · answered by Studley Von Longshlong 4 · 0⤊ 3⤋