Whenj using a multimeter to test for continuity which of the folowing steps are correct ie
1 : Select DCV range
2 : connect the red lead to VOHM,A socket and the black lead to COM
3 : Set the meter to the highest resistance range possible
A : 1 only
B : 1 and 2 only
C : 2 only
D : 3 only
2006-11-04 01:05:38 · 4 answers · asked by Micko52 1 in Computers & Internet ➔ Other - Computers
D
2006-11-04 01:14:52 · answer #1 · answered by shreekant s 2 · 0⤊ 0⤋
You can't do a complete test with a multimeter, but: Given that a coil is a direct short to DC (except for wire resistance), you can look for a very low impedance. If it is a very high impedance, then the coil is bad. What you can't tell is if there is a short in the coil, just an open.
2016-05-21 22:53:40 · answer #2 · answered by Anonymous · 0⤊ 0⤋
Continuity is tested only in Resistance range.
Use the highest range and go to the lower level.
D is correct
2006-11-04 01:16:44 · answer #3 · answered by essbebe 6 · 0⤊ 0⤋
d:3 ONLY
2006-11-04 01:16:16 · answer #4 · answered by jagdeora 3 · 0⤊ 0⤋