How to Disassemble a 1977 Chevy Van Tilt Steering column?

Question

Anyone know how to disassemble a tilt steering column?
need to tighten up the tilt mechanism but can't get to it.
all visible fasteners has been taken off but still can't
get to it.
.
Anyone have any knowledge on how to get to the tilt
mechanism?

Answer 1

Everything you want to know, with pictures.

Answer 2

Check for a snap ring holding the column section to the shaft(good snap ring pliers needed with long tips)not easy to see on some.
but don't forget to use a column lock ring compressor to re-install the snap ring that holds the steering column lock ring down or else the snap ring can be distorted during assembly and come loose firing the lock ring at you from the force of the spring underneath it very dangerous if realy close !

Answer 3

BREAKING information FLASH!!!**********hi! robin, i merely regarded at ur profile, see that ur in atlanta! slightly a the thank you to hold it right here lol ;-) in case you attempt to handle that activity you additionally can substitute a a million/4' tension socket for the torx bit (that's going to ought to be a "12point"nevertheless,)i dont endure in ideas the dimensions yet its uncomplicated in maximum prevalent device kits ,in case you have some techniques now.which will keep you from having to purchase the specific torx bit.**********you will choose 2 forte uncomplicated techniques to do the activity,a million a steerage wheel puller and 2 a small socket called a "opposite torx socket" and 2 different uncomplicated techniques,first pull off the horn cover,then use the steerage wheel puller to do away with the steerage wheel.next a phillips screwdriver to do away with the turn sign take care of,then loosen the screws to the turn sign mechanisim and pass it off to the realm (dont pull to confusing on the wires) then you definitely ought to be sure the "opposite torx" screws down interior the column.you will choose a socket extension at this element(additionally use a million/4 inch tension techniques.they in good condition down interior the column extra effective)tighten those as much as do away with the wiggle. in case you reside everywhere close to auburn hills, michigan (by way of the palace the place the "pistons" play) i will do this restore in my keep.its a $50 fee. sellers fee a minimum of $one hundred or extra. its approximately an hour/hour and a 0.5 activity. in case you purchase the techniques that's going to be around $30 your first time doing the activity(in the experience that your routinely vulnerable)consistent with hazard 3 hours?while you're community and can like me to do the activity you are able to email me by way of this website