I have Epson stylus C45 printer and I am trying to install it on windows 98. whenever I try to install the driver from cd it does not take USB port instead it takes LPT1 I have tried add hardware tool on windows also but it is not taking usb port. Please help!!!
2006-11-01 16:39:20 · 7 answers · asked by sandy 2 in Computers & Internet ➔ Hardware ➔ Printers
try dropping in the install cd, then dont install anything till u plug in the printer
2006-11-01 16:41:51 · answer #1 · answered by myothernewname 6 · 0⤊ 0⤋
Take the Installation C.D and then remove the cable of the printer from the C.P.U then replug then insert the C.D. in the C.D drive and then get start installation in the mean time switch on the printer and if the printer get detected then no problem if not please check the port and if U are unable to detect what is the problem then call for the engineer or the technical support if U R computer is the company Computer.
2006-11-03 01:56:15 · answer #2 · answered by Ramasubramanian 6 · 0⤊ 0⤋
it somewhat is complicated to respond to without understanding the variety extensive type sparkling any loose paper from the paper tray. this might help you detect the jam. you will locate it the two in front, close to the paper tray, or interior the returned, by potential of commencing the rear door. make specific there is not any paper or debris hidden everywhere. Open up the rear door and use a flashlight to locate the interior. in case you notice any paper, have persistence in attempting to eliminate it, now gently pull using a side to side action. in case you employ a gadget for advice, like a pair of tweezers, or pair of needle nostril pliers, positioned some tape on the jaws of the pliers to help preclude the shredding of the paper. yet another good merchandise to have on hand is a can of compressed air. it somewhat is used to blow out any equipped up airborne dirt and dust or effective paper debris which would be embedded interior the printer and the sensors after lots use. Reboot your laptop
2016-12-28 10:03:51 · answer #3 · answered by ? 3 · 0⤊ 0⤋
You have to install USB drivers for Win98, check out USB cables. If everything is ok, then when you connect printer with USB, it should identify the new hardware
2006-11-01 16:44:09 · answer #4 · answered by Guru 3 · 0⤊ 1⤋
Epson are POS get a HP there a lot better quality. Oh and it might be time to upgrade your operating system too, no one uses 98 any more.
2006-11-01 18:29:46 · answer #5 · answered by gdearth 2 · 0⤊ 0⤋
theres a problem with te usb port change the usb port u r usining
2006-11-02 16:39:30 · answer #6 · answered by ukmad 3 · 0⤊ 0⤋
call someone to come to your house to fix your computer
2006-11-01 16:50:05 · answer #7 · answered by Anonymous · 0⤊ 1⤋