i bought the pulley holder from a tool suppler but we still can not get the bolt loose to take the housing off. any help would be great.
2006-10-30 12:42:01 · 4 answers · asked by boslayde2006 1 in Cars & Transportation ➔ Maintenance & Repairs
buy a CHAIN WRENCH.it is what it sounds like.
2006-10-30 12:44:52 · answer #1 · answered by spencer 3 · 0⤊ 0⤋
Check the maintenance manual. Make sure it isn't a left hand thread. Sometimes the crank pulley nuts are reverse threaded. Plus, its gonna be on there really tight (mine on my rx7 was well over 300 ft#'s). Use a breaker bar with a pipe on it for leverage.
2006-10-30 20:58:29 · answer #2 · answered by Steve-o 3 · 0⤊ 1⤋
you are going to have to get it to a shop to crack the nut loose because you need about 160 psi from a compressor feed to even loosen Du to the fine threads on nut tried other methods on same car had to comply defeet
good luck
2006-10-30 21:17:30 · answer #3 · answered by dr car g 2 · 0⤊ 0⤋
we have had to use a torch on some pulleys,the locktite some of the carmakers are using wont let go untill you get it warm/hot
ase tech
2006-10-30 21:52:14 · answer #4 · answered by moe h 4 · 0⤊ 1⤋