I installed a new brake light switch because the old one was not woking. When I removed the old switch the contact plate was popped out of its pivot point. I installed the new one, and the lights worked until I pressed the brakes hard( almost to the floor). I removed the new switdh to find the same problem as the old one had which I had just removed. The pedal assembly has minimal play in it but I don't think it is enough to cause this failure.
2006-10-29 06:52:31 · 2 answers · asked by rob m 1 in Cars & Transportation ➔ Maintenance & Repairs
replace front and rear brake pads, reset your rear brakes after that by going in reverse about 5 miles an hour or so and tapping on your brakes, you will hear a clicking, that is the brake assembly in the back self-adjusting - bleed the brakes / all that will have the brakes coming on a-lot sooner and firmer - meaning your pedal wont be going that far
2006-10-29 07:18:10 · answer #1 · answered by hell oh 4 · 0⤊ 0⤋
if you have a soft brake pedal and its traveling to far down you will see this problem
2006-10-29 15:02:25 · answer #2 · answered by Christian 7 · 0⤊ 0⤋