English Deutsch Français Italiano Español Português 繁體中文 Bahasa Indonesia Tiếng Việt ภาษาไทย
All categories

the powder compartment empties but the softner part is always still there when wash has finished? have cleaned it all out but still the same?

2006-10-26 20:17:04 · 9 answers · asked by greenfingers J 3 in Home & Garden Cleaning & Laundry

9 answers

take out the drawer, thoroughly clean it, and the surrounding area, the softener cup gets blocked usually when too much soap powder is put into the drawer, so put a little less powder in on each cycle.

2006-10-26 20:26:22 · answer #1 · answered by a1ways_de1_lorri_2004 4 · 0 0

On most machines the softener syphons out of its compartment when it gets filled with water on the rinse cycle. there may be a small removable bit in the drawer, part of which forms the syphon. you must make sure this part is nice and clean and clear, else it wont work...toothbrush, knitting needle....

2006-10-26 23:01:46 · answer #2 · answered by johncob 5 · 0 0

The other answers might work if not get some one to check the water valves.You could have three valves one to let in hot water one to let in cold water for the soap compartments and one to let in water for the softener the cold and softener are normally a twin valve. The valves are located where your hoses connect to

2006-10-26 20:46:46 · answer #3 · answered by rocky 3 · 0 0

It might be plugged... Take it out and wash it. I have to do that from time to time.. It sometimes gets rather dirty in that area to include the place where the soap powder goes in, etc... so just wash out the whole thing

2006-10-26 20:22:07 · answer #4 · answered by Anonymous · 0 0

Are you using a concentrated fabric conditioner? Try using the non-concentrated kind or dilute the concentrated one. I find this works for me. Even if I've just cleaned out the drawer the machine won't take it up if I use concentrated.

2006-10-26 20:48:45 · answer #5 · answered by JustMe 2 · 0 0

I have that all the time I put too much powder in so it goes all gunky behind the draw and have to take it out and wash it and inside the draw too .

2006-10-26 20:34:12 · answer #6 · answered by stephy200125 2 · 0 0

You have chosen a cycle that does not add softener on the final rinse or your programmer is knackered.

2006-10-26 20:31:12 · answer #7 · answered by Anonymous · 0 0

the problem with the washer is that the solid in the washer is not working u need a new solid if u stll have a problem email me at domesticelectricalservices@yahoo.co.uk

2006-10-27 01:26:39 · answer #8 · answered by michael w 2 · 0 0

check the filter must be blocked... should be twity thing at the bottom,, i get that aswell sometimes.... full with washing pegs money and lard crap lol

2006-10-26 20:19:55 · answer #9 · answered by stuio 3 · 0 1

fedest.com, questions and answers