i took the old starter out, but it was a broken bolt in there, i tried drilling it out but it didnt work as expected, i tried holding the new starter with one bolt but it didnt work!!!!!im really frustraded and about to call a donation center!!!!!
2006-10-26 13:28:57 · 6 answers · asked by robertomusa 1 in Cars & Transportation ➔ Maintenance & Repairs
get a tap set and match the thread with the bolt drilling does not cut threads but a tap will. after you tap out the hole the bolt will screww in and tighten up
2006-10-26 13:38:46 · answer #1 · answered by staqk3 2 · 0⤊ 0⤋
What didn't work in the drilling process ?? If you can get a hole thru the bolt you might get an easy out to work. I have removed many bolts with a small chisel. catch the outer edge and slowly back it out. Does it protrude so you could get vise grip on it ??
Maybe tell us a little more.
2006-10-26 14:18:04 · answer #2 · answered by tronary 7 · 0⤊ 0⤋
What kind of car might help. If the bolts go through the bell housing, try going all the way through and putting a nut on the other end.
2006-10-26 15:56:05 · answer #3 · answered by TonynNC 5 · 0⤊ 0⤋
see if theres a place to put a brace to hold it tight.
2006-10-26 13:32:33 · answer #4 · answered by Anonymous · 0⤊ 0⤋
ducktape, condom, rubber band, twisty tie, and a plastic straw... then hunt down chuck norris!!!
2006-10-26 13:39:14 · answer #5 · answered by Bones 1 · 0⤊ 0⤋
SORRY BUT KEEP ON DRILLIN
2006-10-26 13:32:52 · answer #6 · answered by midnighttoker 3 · 0⤊ 0⤋