2006-10-24 10:20:29 · 16 answers · asked by hmbn 4 in Entertainment & Music ➔ Polls & Surveys
fqkf90, that was so hurtful... but also very funny :)
2006-10-24 10:24:02 · update #1
Well, heck honey. You most certainly can put that square peg in the round hole. Trust me on this one. Just grab you a big old hammer and start to swinging. You'll get it in there eventually, but you might never get it out again either.....so at least you won't have to worry about safety wire or lock nuts.
To a true mechanic, nothing is impossible........some things are just a wee bit more difficult. :)
2006-10-24 10:27:44 · answer #1 · answered by Shadow 7 · 1⤊ 0⤋
You can if the round hole is much larger than the square peg, but otherwise, the corners prevent it from going in.
2006-10-24 17:26:54 · answer #2 · answered by Anonymous · 0⤊ 0⤋
You can if the square peg is smaller then round hole.
You could also sand the edges off the square peg and make it rounder for a better fit.
2006-10-24 17:22:55 · answer #3 · answered by Anonymous · 1⤊ 0⤋
is there any significance in the fact that you can probably get a round peg in a square hole?
2006-10-24 17:24:25 · answer #4 · answered by icknblick 2 · 0⤊ 0⤋
Try plugging that hole in you head with a 2 x 4
2006-10-24 17:22:39 · answer #5 · answered by AL 6 · 0⤊ 0⤋
that would be possible if you used a hammer to pound the peg in the hole
2006-10-24 17:22:43 · answer #6 · answered by dishwasher67 6 · 0⤊ 0⤋
because the hole is too small, try putting it in a bigger round hole.
2006-10-24 17:22:57 · answer #7 · answered by luv78779 2 · 0⤊ 0⤋
You can do it. File the square corners. Then get a hammer.
2006-10-24 17:25:35 · answer #8 · answered by Anonymous · 0⤊ 0⤋
the round hole is not big enough
2006-10-24 17:23:05 · answer #9 · answered by William J 1 · 0⤊ 0⤋
You're just not using the proper amount of force.
It'll fit, believe me.
2006-10-24 17:22:59 · answer #10 · answered by Anonymous · 1⤊ 0⤋