How does one run wire in concrete to add a plug?

Question

My condo has only one plug on the wall to the kitchen counter. I know how to add a plug, but the wall is concrete/block with one layer of drywall attached to it. I'll also be adding tile as a backsplash. Do I make a groove in the drywall and run metal sheathed wire (covering later with tile). And what about the box, do I just chip out just enough for a special shallow box? Don't want to incur any problems later....any advice from actual electricians as to how they do it...

Answer 1

The normal procedure is to hack a groove for the PVC conduits
and socket box in the brickwalls
If you say it's concrete, I'd rather run an exposed PVC conduit
Because concrete cover for reinforcement bars is not sufficient to take in the round PVC conduit and socket

Answer 2

Easiest, most affordable solution "Race Track" surface mount molding.

Not knowing your location,,,in the USA Home depot/Lowes sells all the needed components.

What you need is the hollow, usually rectangular shaped tubing, that has a "backer" that allows the wiring to be enclosed. Then brackets are available for mounting, which can be accomplished with tap cons, etc. The system also allows joints, elbows, and receptacle "boxes" There are usually,,,in the section of the store devoted to that item,,,, recepticals and switches specifically designed for the lower profile of the BOX.

Rev. Steven

Answer 3

I used a small jackhammer when I remodeled our kitchen and added receptacles to the fire wall which was rock hard brick.

Answer 4

better to run surface mounted wire moulding