2006-10-22 21:33:09 · 6 answers · asked by Sassy_One 2 in Cars & Transportation ➔ Maintenance & Repairs
as far as control modules go I just replace them if needed...but seldom is it needed...control modules are just the updated versions of the points and capacitor that used to be in the distributor...I believe you may be looking to access your onboard systems computer...which might be located under your floorboard...you can jack in using a laptop and run some programs...even while driving...hope that helps...gl..
2006-10-22 21:38:43 · answer #1 · answered by Anonymous · 0⤊ 0⤋
Replace the module to clear the codes? Hard to believe someone that smart can actually type.
Get an OBDII scanner for about $70. You'll be able to read and clear the codes on any vehicle built since 96.
2006-10-23 01:06:58 · answer #2 · answered by Nomadd 7 · 0⤊ 0⤋
Grand Prix's are in simple terms commonplace autos with some sporty overtones. no longer rapid, in simple terms sufficient power to get around from element A to point B without being underpowered. additionally particularly solid with the GM 3800.
2016-12-16 12:36:31 · answer #3 · answered by ? 4 · 0⤊ 0⤋
if your talking about the on board computer and engine codes then you can go to any autoparts store and they can check them for you and sometimes even tell you what they are if not then you are going to have to get a Haynes manual and then look them up. Sometimes even transmission shops will check the codes for you and most places won't c harge you for the check.
2006-10-22 23:30:55 · answer #4 · answered by handyman 4 · 0⤊ 0⤋
Most garages who have a scanner can clear your codes, expect to pay something, for there time.
2006-10-22 21:49:06 · answer #5 · answered by acowboydave 2 · 0⤊ 0⤋
I think, you can disconnect the negative battery terminal for a few minutes and it removes them. They will Reset after you drive for a few miles.
2006-10-22 23:27:47 · answer #6 · answered by Anonymous · 0⤊ 0⤋