My TB squeeks like crazy when I turn or go over a bump....the following conditions apply:
The tires do not show signs of wear; It handles fine; no shaking in the stering wheel; the front does not bounce when I push down on it; ....when it rains it does not squeek at all.......does anyone have any ideas what it could be ? Is it something I could tackle myself ? I know basic car repair but I can't do technical things.
I have checked under the front and do not see any oil or fluid leaking....This is very perplexing. Thanks for any advice ya'll can give me.
2006-10-22 12:38:56 · 6 answers · asked by I know a thing or two 1 in Cars & Transportation ➔ Maintenance & Repairs
The control arm bushings are dry. But don't squirt them with brake fluid like someone said. That will make the rubber swell and eventually dry out and disintegrate.
Use some Wd 40 or Pb Blaster. Have someone bounce up and down on the car so you hear the squeak and spray where you hear it. When the squeaking goes away. Stop spraying
2006-10-26 12:11:53 · answer #1 · answered by whtsthislif4 5 · 0⤊ 0⤋
Its your control arm bushings. Squirt them with brake fluid or try a good penetrating oil(not wd-40)Use kroil or PB blaster
2006-10-22 13:58:50 · answer #2 · answered by R1volta 6 · 0⤊ 0⤋
If the squeeking occurs when you turn your steering wheel, it sounds like your lower ball joints have seized up, and need replacing. Try steering it with the vehicle stationary, if the sound you are complaining about appears, then it's your lower ball joints for sure.
2006-10-22 12:53:11 · answer #3 · answered by Anonymous · 0⤊ 1⤋
nicely, via fact the 4.6 grew to become into an selection youll have sufficient room to place approximately something in there if youre keen to do the artwork. you ought to even throw a 460 in there in case you had to.
2016-11-24 23:16:40 · answer #4 · answered by Anonymous · 0⤊ 0⤋
The bushings are dry.
2006-10-22 12:44:09 · answer #5 · answered by gdwrnch40 6 · 1⤊ 0⤋
belts
2006-10-22 12:43:01 · answer #6 · answered by Anonymous · 0⤊ 0⤋