If I have two of the same exact guitar amps, is there any way to connect the two to make one louder amp?

Question

i have two peavy 50 watt amps and i was wondering if i could connect them to get a simmiliar effect of a 100 watt peavy amp

Answer 1

You could do what Wade said much cheaper with a Y-splitter

Also, if your amps have two inputs on each amp, you can run your guitar signal chain as follows:

Go guitar to input 1 on first amp. Run a cable from input 2 on the first amp into input 1 on the second amp. According to how your amp is set up, this may allow you to run both amps at the same time as well. This is how many classic amps like the Fender Twin Reverb were designed. On those amps you actually ran from the input 2 on the clean channel to the input 1 on the vibrato channel allowing you to push the amp into louder territory by running both channels at once. I've also done this with my Polytone and Acoustic Control amps.

Answer 2

buy a effect pedal with two outputs, and run each output to each amp........I have 2 marshall DSL 100 stacks and i run a boss super chorus between my Les paul and the marshalls and it sounds awsome and it sounds louder than just by running one amp.