2006-10-17 03:06:45 · 5 answers · asked by October 1 in Cars & Transportation ➔ Maintenance & Repairs
If it is the same as in a Scion(which i imagine it is) turn on the car, pop the button to the out position, then hold it in for 2-3 seconds and it should be set. And don't waste time and money going to a garage. It is in your owners manual. If you can't find your owner's manual, go to the toyota website. they have FAQs and a user forum where you can get answers, and they even have some of the owner's manuals online. Hope this helps!
2006-10-17 03:18:36 · answer #1 · answered by Jon C 6 · 0⤊ 0⤋
If you get a tire pressure light you do need to check all your tires. Including your spare. I am not sure what the factory recommended inflation pressure is. As long as you set your tires to what the factory sticker on the drivers side door jam stats the tires should be. I believe your spare is a full size spare which will also have the factory pressure the rest of the tires use. Once you set the tire pressure on all the wheels you now need to find the tire pressure switch which is located either on lower drivers side instrument panel under the the steering wheel or the glove compartment. Once you find it turn the ignition on the ON position and you need to press it for about five seconds and look at your tire pressure light to blink. Once it start blinking continue to hold the switch until its stops blinking again. Cycle the key on and off. After this it sometimes takes a day for it to clear. If it doesn't clear you may have a problem with your sensors in which case you need to go to an authorized service shop to verify this condition. If you do have a faulty sensor and you are still under warranty the replacement of this sensor will be covered. But it is rare these sensors go bad unless they have been damaged by a tire shop not removing the sensors before replacing tires. Hope this helps The link below is some information on the system itself. Not necessarily a help you fix it site The second link is a help you fix it site. But they do not do this in a way the factory does. It will mainly help you find the switch and if you are having trouble clearing the light with the way I told you.
2016-05-22 08:30:33 · answer #2 · answered by ? 4 · 0⤊ 0⤋
open the door 3 times with the key in the ignition. Pop the hood and shut it 4 times and then remove the battery for 5 minutes.
2006-10-17 03:32:02 · answer #3 · answered by Karrien Sim Peters 5 · 0⤊ 0⤋
turn key on,hold down the tire rest button located on the left side of the steering wheel until the tire pressure warning light blink 3 times.now turn the key off and then start the vehicle and light will turn off
2006-10-17 04:08:57 · answer #4 · answered by LEXUSRY 5 · 0⤊ 0⤋
Take it to your local garage and ask for assistance
2006-10-17 03:14:58 · answer #5 · answered by Anonymous · 0⤊ 0⤋